At 1:01P.M, a thermometer reading is 90°C is taken outside where the air temperature is -10°C. At 1:03P.M, the reading is 36°C. At 1:07 P.M, the thermometer is taken back indoors where the air temperature is at 90°C. What is the thermometer reading at 1:10P.M?

At 1:01P.M, a thermometer reading is 90°C is taken outside where the air temperature is -10°C. At 1:03P.M, the reading is 36°C. At 1:07 P.M, the thermometer is taken back indoors where the air temperature is at 90°C. What is the thermometer reading at 1:10P.M?

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter11: Calibrating Instruments

Section: Chapter Questions

Problem 7RQ: Accuracy of a thermometer is more important in the ______temperature ranges.

See similar textbooks

Related questions

Q: Write the shear and moment equations and draw the shear and moment diagram:

Q: 2.36 WP As shown in Fig. P2.36, an oven wall consists of a 0.635-cm-thick layer of steel (x, = 15.1…

A: (a) The thickness of the brick layer : 11.25 cm. (b) The rate of conduction : 1.6645 kW/m2

Q: Part A The mechanism shown in the figure (Eigure 1is used to raise a crate of supplies from a ship's…

Q: Why should the machine be kept clean and properly oiled?

A: Corrosion, and as we all know, that's not good for machine operation. This prevents the production…

Q: There is an air hockey table in the treehouse! Find the x and y components of the final velocities…

A: law of conservation of momentum states that : net momentum before impact = net momentum after impact…

Q: Problem 1. For the plane area shown below, determine the location of the centroid with respect to x…

Q: A sink of strength 20 m2/s is situated 3 m upstream of a source of 40 m²/s in a uniform stream. It…

A: Soln:-in this problem Sink strength = ^ =20 m^2/s R= 3 m We know, Radial velocity = vr = ^/2πr…

Q: DETERMINE ALL THE FORCES ACTING ON THE SYSTEM GIVEN THAT THE SPRING CONSTANT IS EQUAL TO 20 LB/IN…

Q: A hole is to be punched out on a layer of papers using a puncher with a hole diameter of 100 mm. If…

Q: A water jet washing system for galvanized steel profiles uses a series of n = 15 nozzles mounted on…

A: Given : To find : a) The total flow demanded from the compressor if a discharge velocity of not…

Q: 2. A vapor-compression refrigeration system operates on throttling expansion. The refrigerant is…

A: Refrigerant= Tetrafluoroethane R134aEvaporation temperature, Te=272.15 K -1oCCondenser temperature,…

Q: Calculate the enthalpy of combustion of propane C3H8 at 25 oC in both kJ/kg and kJ/mole under the…

Q: What should the operator of a milling machine do to make the machine a safe piece of equipment?

Q: Ambient air with a dew point of 1°C and a relative humidity of 60% is conveyed at a rate of 1.5 m3/s…

Q: A section of uniform pipe is bent into an upright U shape and partially filled with water, which can…

A: Given data Inner radius of pipe = r = 0.024 mDensity of water = ρ = 1000 kg/m3g = 9.81 m/s2

Q: A 150 mm-diameter water jet sticks horizontally the 30° deflector as shown in figure below. The…

Q: 2. An investment of 105,815.40 can be made in a project that will produce a uniform annual revenue…

A: To study the economics we use these six methods:- Present worth method (PW):- Future worth method…

Q: 12 kips 4 kips D. 2 ft - 6 ft - 4 ft

Q: the back work ratio and the thermal efficiency of the cycle assuming a regenerator with 75 and…

Q: Problem 4: Derive the response of the following first order system to a step input. mủ + cv = f…

Q: a mass of 1673 kg. The coefficient of static fricti ees] that the car can drive up if it has…

Q: A pulley system is carrying a 90 kg object as shown in Figure Q5. The total weight and the radius of…

Q: 2. Calculate the resultant of hydrostatic force on the gate. What force P is necessary to lift the…

A: To find Force P

Q: (10) A cast steel pulley attached to a 50mm shaft is transmitting 30kW @ 200rpm, and is keyed by a…

A: Find the factor of safety of the key.

Q: Q-2: The woman exercises on the rowing machine. If she exerts a holding force of F = 350 N on handle…

A: Answer: (a) The horizontal and vertical reaction at point C: Rc,x = 818.1333 N ; Rc,y = 105.3105 N…

Q: D5: For the given state of stresses shown, draw the required Mohr's circle and ctermine: The…

Q: 800 lb/ft 2 ft 4 ft 2 it-

Q: Create a flowchart about Corrosion and its types of Corrosion Types of Corrosion 1.) Uniform…

A: The flow chart is the graphical representation of the topic using different shapes and arrows .

Q: 5.17 Determine the maximum bending stress in the steel beam with the circular cross section. 400 lb…

Q: A shaft groove with a length of 250 mm and a depth of 12 mm is cut by a 20 mm diameter slot cutter.…

A: Given:L=250 mmh=12 mmD=20 mmd=4 mmf=25 mm/minLo=12*D

Q: A train mechanical system shown in Figure 1, consist of engine draw a car moving in one direction.…

Q: 47 PHYSE 40.0 cm 20.0 cm 80.0 cm Figure shows uniform solid cylinder 80.0 cm long and 40.0 cm in…

A: Here, complete cylinder is the combined shape which is made of Shape 1: Sphere being removed and…

Q: A rotating cylinder viscometer is used to measure the viscosity of fluids. The viscometer we are…

A: Given data:

Q: The vehicle shown starts from rest at the bottom of the hill and accelerates up the hill due to the…

A: Given data mass of car = 1600 kgFR = 7300 Nvtop = 9.7 m/sh = 50 m

Q: Two infinite black plates of 800deg C and 340 deg C exchange heat through radiation. Calculate the…

Q: An uncontrolled 1050 kg car strikes squarely a motorway crash cushion in which the car is brought to…

A: Given data Given datamass of the car = 1050 kgThe length of the crash cushion = 6.1 mThe magnitude…

Q: calculating the engine's output.

A: To find engine's output.

Q: Q2/ The equation of a velocity distribution over a plate is u=1/3 y - y in which the velocity in m/s…

Q: H.W The brakes are applied to a vehicle with a mass of 2 Mg while it is descending a l-in-7.8…

Q: )A kid is playing with a 4 kg skateboard as shown in Figure Q2 (b). The boy with mass of 40 kg jumps…

A: Find the maximum distance , s.

Q: 6-13 A brass rod is a firm fit inside a steel tube 2 cm inside diameter and 4 cm outside diameter…

A: When the materials are at 15 degrees C, we have a brass rod that is a firm fit inside a steel tube…

Q: 10. A hydroelectric power station is required to generate a total of 4.2 MW from a number of…

Q: Problem 2. The homogeneous wire ABCD is bent as shown and is attached to a hinge at C. Determine the…

Q: Water at 10°C flows through the system shown in the figure below at 0.34 m/s. Energy loss in the…

A: pump total head = static head + total dynamic head in fluid mechanics we do not bother about sign.…

Q: Griven olatu MaRs of bal - 2K Velor orf boll= 1 m/s velacity Iind Kinedic energy

Q: 1. Water flows into a 3m vertical pipe and into a 2m horizontal pipe before discharging into the…

A: given; diameter of pipe(d)=2*12 =24cmvelocity(V)=4m/sdensity of…

Q: 3. (a) Using Stress transformation equations, determine the principal planes, the principal…

Q: Give an example of a nanomaterial that has electron confinement in a single dimension.

Q: Select the correct answer. 1- In figure (1) what the type of gear a- Rack and pinion c- Spur gear…

A: As per our guidelines, we are supposed to answer only first three subparts in case of multiple…

Q: 60 min 24 mm 180 mm O1// Determine the principles strain for the point (A) of the bar which 32 mm…

A: given; axial force in x-direction(Fx)=1KN (tensile)…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

4. At 3:01P.M, a thermometer reading is 90°C is taken outside where the air temperature is -10°C. At 1:03P.M, the reading is 36°C. At 1:07 P.M, the thermometer is taken back indoors where the air temperature is at 90°C. What is the thermometer reading at 1:10P.M?
At 2:00PM, a thermometer reading 70°F is taken outside where the air temperature is -10°F. At 2:04PM, the reading is 26°F. At 1:08PM, the thermometer is taken back indoors where the air is at 70°F. What is the thermometer reading at 1:14PM?
A thermometer reading 75° is taken out where the temperature is 20°F. The reading is 30°F four minutes later. Find: a. the thermometer reading seven minutes after the thermometer was brought outside and b. the time taken for the reading to drop from 75°F to within a half degree of the air temperature.
At 1:00 PM a thermometer reading 70°F is taken outside where the air temperature is −10°F (10 below zero). At 1:02 PM, the reading is 26°F. At 1:05, the thermometer is taken back indoors where the temperature is at 70°F. What is the thermometer reading at 1:09 PM?
At 12:00 noon a thermometer reading 60o C is taken outside, where the air temperature is 24o At 12:02 PM the reading is 89.6o F. Later the thermometer is brought inside where the temperature is 60o C. At 12:10 PM, the reading is 58.24o C. When was the thermometer brought inside?
yquandj3iakzjwkoqKd ywuajxjeuiqias jgo4oajzuwuq udiqijNxjd 4. At 1:00P.M, a thermometer reading is 70°F is taken outside where the air temperature is -10°F. At 1:02P.M, the reading is 26°F. At 1:05 P.M, the thermometer is taken back indoors where the air temperature is at 70°F. What is the thermometer reading at 1:09P.M?
A thermometer is removed from a room where the temperature is 70° F and is taken outside, where the air temperature is 10°F.After 3 minutes the thermometer reads 60°F. What is the reading of the thermometer after 7 minutes?
This indoor-outdoor thermometer shows the temperature readings for awinter day. What is the temperature difference?
A thermometer measurement of 158°C is taken outside at 59°C inside. After 5 minutes, the temperature is 113°C. After 5 minutes, the thermometer is taken indoors to 158°C. What will the temperature be 10 minutes after bringing the thermometer inside?
The Sahara desert with a very arid climate is one of the hottest regions in the world. Its average temperature is above 30°C or 86°F. In a 24-hour period, the temperature can go from a day-time high of 95°F to a low of 32°F at night. (a) By how many Celsius degrees does the temperature fall in the 24-hour period? °C (b) By how many Kelvin degrees does the temperature fall in the 24-hour period? K
At 3:00 PM, a thermometer reading 25 °C is brought outdoors, where the air temperature is constant at 17 °C. At 3:05 PM, the thermometer reading is 21 °C. Later, the thermometer is taken back indoors where the air temperature is constant at 25 °C. At 3:15, the reading is 20.3 °C. When was the thermometer exactly brought indoors?
The air temperature is 40 degrees F when brought into the room where the thermometer reading is 55 degrees F. After four minutes, the thermometer reading is 45 degrees F. Find the thermometer reading ten minutes after it is first brought into the room.