b) Based on Figure 4-1 shown below, the Fa0/2 interface on switch S1 is “shutdown" after switchport port-security mac-address CAFE.AABD.888A command entered the switch Sl. Anticipate what caused the reason that the Fa0/2 interface is shut down. Explain your view. Fa0/1 Fa0/24 Fa0/2 PC1 R1 S1 sii show port-security Secure Port MaxSecureAddr CurrentAddr SecurityViolation Security Action (Count) (Count) (Count) Fa0/1 1 Shutdown Fa0/2 1 Shutdown Total Addresses in System (excluding one mac per port) : 0 Max Addresses limit in System (excluding one mac per port) : 8192 Figure 4-1: A network topology

Q: The exhibit shows a small switched network and the contents of the MAC address table of the switch.…

A: Actually, MAC address (Media access control) is an address defined at layer 2 (Data link layer) of…

Q: (la) Check the appropriate boxes below Instructions Activity - Switch It! Determine how the switch…

A: Question 1: Where will the switch forward the frame? Answer: Fa5 Switch forward to the frame.

Q: Do we need to configure MAC address on hosts, switches and routers? Explain b) Draw the switch table…

A: Switch Operation What AN local area network Switch willEthernet switches link local area network…

Q: Which table is built by the switch to record the Source MAC address and the port it was received. a.…

A: A MAC address table, sometimes called a Content Addressable Memory (CAM) table, is used on Ethernet…

Q: As a network trainer in a acre company, you are asked to explain in your own words the following…

A: 1) A switch builds its MAC address table by recording the MAC address of each device connected to…

Q: Which of the following statements is true about NIC (Network Interface Card)? There might be…

A: Statement 1) When operating in "promiscuous" mode, NIC passes every frame received from the network…

Q: How does Switch learn Mac Address when pc1 wants to communicate with pc2 and pc3? Explain the…

A: Process for building the MAC Address Table on Switches: Switch works at data link layer and it uses…

Q: How does Switch learn Mac Address when pc1 wants to communicate with pc2 and pc3? Explain the…

A: Process for building the MAC Address Table on Switches: Switch works at data link layer and it…

Q: With reference to the figures depicted below, illustrate what does a switch do when it receives a…

A: Note: As you have asked a multipart question, as per our policy, we will solve the first three parts…

Q: normal situation, a switch will only forward a unicast frame to a switch port according to the…

A: It is defined as a media access control address (MAC address) is a unique identifier assigned to a…

Q: Question 4: (17 marks) From the MAC address 4E:A2:C6:BB:D9:C8 determine the IPv6 address Interface…

A: 1 PC-A to PC-B. Both PCs are on the same VLAN. The MAC Address of PC-A is not yet registered in the…

Q: What is the difference between a layer 2 and layer 3 switch? If you were to buy a switch which one…

A: Given: What is the difference between layer 2 and layer 3 switches? If you were to buy a switch…

Q: Suppose the destination not stored in the MAC table, what will happen no option is correct the…

A: Hello student. Greetings from my side. Hope you are doing great. I will try my best to answer your…

Q: Write down the commands to configure each step Assuming SW1 is a 24 port switch. Connect PC1, PC2,…

A: A.Consider SW1 is a 24 port switch. Connect PC1, PC2, PC3, PC4, and PC5 on ort 6,8,13,17 and 21…

Q: Refer to the exhibit.   S1(config-if)# switchport port-security S1(config-if)# switchport…

A:

Q: What is the value of each field in the ARP message that R1 sends out to inquire about R2's MAC…

A: Answer: The value of each field in the ARP message that R1 sends out to inquire about R2's MAC…

Q: Suppose the destination not stored in the MAC table, what will happen no option is correct the…

A: Lets see the solution in the next steps

Q: Suppose the destination not stored in the MAC table, what will happen no option is correct the…

A: Hello student. Greetings from my side. Hope you are doing great. As per our company guideline's, in…

Q: Some new two-layer switches, called _______ switches, have been designed to forward the frame as…

A: Answer to the above question for 2 layer switch is detailed in step2.

Q: As a Network Admin, how can you identify if a system is using DHCPV4 or v6 by modifying hardware…

A: The answer is

Q: With reference to the figures depicted below, illustrate what does a switch do when it receives a…

A: What does switch do when it receives a frame from PC0 destined to PC2.

Q: If a switch receives a frame and the source MAC address is not in the MAC address table but the…

A: Correct answer is Option C  As the source MAC address is not present in the MAC address table the…

Q: Which command will display the current contents of the ARP cache on the local workstation?

A: The command is => ARP -A

Q: Suppose the destination not stored in the MAC table, what wwill happen no option is correct the…

A: MAC table is used by switch to map the MAC addresses to specific interface on switch.

Q: Configure the following VLans having a single switch. VLan 22, Dept. HR     (Ports: fa0/1)   VLan…

A: Q: Configure the following VLans having a single switch. VLan 22, Dept. HR     (Ports: fa0/1)…

Q: As a network trainer in a acre company, you are asked to explain in your own words the following…

A: A switch builds its MAC address table by recording the MAC address of each device connected to each…

Q: Assume that you ale culently logged S2.ConFigure the Port security on Switched interface…

A: It is defined as an addresses are useful for network diagnosis because they never change, as opposed…

Q: Perform the following Assign switch ports to Vlans on (swictch 0/ switch1) Determin which orts have…

A: Addressing Table Device Interface IP Address Subnet Mask VLAN PC1 NIC…

Q: Refer to the exhibit. Priority 32768 MAC 0000.1111.1111 Priority 32768 MAC 0000.1111.2222 Port 1…

A: Dear Student, The root node is the node having highest priority as the priority is same now the root…

Q: Perform Basic Configuration tasks on MUSCAT-SW1 switch. a) Go to global configuration mode b) Change…

A: Perform Basic Configuration tasks on MUSCAT-SW1 switch. Cisco packet-tracer is used

Q: What is the reason 802.11 will not fully break down since the SSID (Service Set Identifier) and MAC…

A: The answer is..

Q: What is the reason 802.11 will not fully break down since the SSID (Service Set Identifier) and MAC…

A: To be determine: What is the reason 802.11 will not fully break down since the SSID (Service Set…

Q: What is the reason 802.11 will not fully break down since the SSID (Service Set Identifier) and MAC…

A: Following is the answer :

Q: Assume that you are cuently lo9gged ne 52. Configure the Port security on Switched interface…

A: It is defined as an addresses are useful for network diagnosis because they never change, as opposed…

Q: In a broadcast Ethernet frame, state the destinatiog Media AccessControl (MAC) address?

A: Broadcast Ethernet frameThe Radio Frame includes an FF-FF-FF-FF-FF-FF-FF-FF hexadecimal MAC address,…

Q: Set up the following: There are two switches on VLans:   Switch 1) VLan 10, Dept. Admin (Ports:…

A: In this problem, we have two switches and we need to configure two vlans for these two switches. We…

Q: Set up the following: There are two switches on VLans: Switch 1) VLan 10, Dept. Admin (Ports:…

A: CISCO PACKET TRACER is used to solve the given problem.

Q: Follow the procedure you used in Activity 7-4 to create a new virtual switch on your UAS-vHost3 ESXi…

A: Lets discuss the solution in the next steps

Q: 25. ___________________To accomodate protocol analyzer, IDS devices, and IP devices,  most switch…

A: Note: I would answer the first question only. If you want answer for other questions, please post…

Q: Configure the following VLans having two switches: Switch 1: 1. VLan 40, Dept. HR 2. VLan 50, Dept.…

A: V LAN is a virtual LAN in this physically system can be placed anywhere but they are logically…

Q: How do I fix remote procedure call failed? 2. Is RPC secure? What causes RPC Server Unavailable?…

A: Given: 1. How do I fix remote procedure call failed? 2. Is RPC secure? What causes RPC Server…

Q: Write an Internetwork Operating System (IOS) commands for configuring the following ports: (Note:…

A: Required: Write an Internetwork Operating System (IOS) commands for configuring the following ports:…

Q: Write an Internetwork Operating System (IOS) commands for configuring the following ports: (Note:…

A: GIVEN: Write an Internetwork Operating System (IOS) commands for configuring the following ports:…

Q: Write an Internetwork Operating System (IOS) commands for configuring the following ports: (Note:…

A: Write an Internetwork Operating System (IOS) commands for configuring the following ports: (Note:…

Q: Perform the following Configure trunking ports on swicthes Ping the following and answer the…

A: In this problem, we will discuss about the trunking ports on switches and then verify the ping…

Q: In a WiFi frame, we have 4 addresses instead of just 2 addresses (source and destination MAC). Draw…

A: In a WiFi frame, we have 4 addresses instead of just 2 addresses (source and destination MAC). Draw…

Q: You have a host and 2 virtual machines. Explain in details how the Network Address Translation (NAT)…

A: NAT – Network Address Translation: ⦁ In NAT, multiple devices are allowed to access the internet…

Q: Socket address is Select one: a. The Port of the program followed by the IP of the device b. The IP…

A: An IP address is a unique device address over the network to identify the device. Port is a logical…

Q: In the given figure below, PC0 is sending a message to PC1 through the intermediate networking…

A: OSI is OPEN SYSTEM INTERCONNECT MODEL is defined basically to transfer data from one system to…

Q: The network administrator decided to deny traffic from PC1to PC4 while permitting it from PCO and…

A: Answer Option A is the Answer no: for standard between1 and 99     Explanation:- A standard ACL may…