Find the current in the conductor through which 2.5 x 1020 electrons pass in 8 sec if the charge

Q: In the circuit above:, the supply provides 3 V, the resistor is 1.66 kN, and the inductor is 13 mH.…

A: The solution is given below The given problem is from series RLC circuit.

Q: Calculate the percent voltage regulation for a three-phase wye-connected 2500 kVA 6600-V…

A: The solution is given below

Q: Given the following voltages and load impedances: Vab = 22020 ° Vbe = 2204240° %3D Vea = 2204120°…

A: In this question,  We need to determine the reading of the wattmeter We know  Reading of wattmeter…

Q: a) s +1 G(s) = (s+0.5 – j)(s+0.5+ j) b) 1 G(s) = (s+3)(s+1) c) 1 G(s) = (s +3)(s +1)(s + 15)

A: Poles: Poles are that frequency that makes the transfer function infinity. It is determined by the…

Q: The following characteristics have been measured on a lossy transmission line at 100 MHz: Zo = 50 +…

A:

Q: Design a logic circuits w/ 4inputs (A(MSB), B,C,D(L,S,B)) and 1 output x. The 4 inputs represent…

A: Truth table: It is a tabular representation of the output and the inputs of the gates. With the help…

Q: 5 minutes 6. What is the instantaneous voltage across a 2-µF capacitor when the current through it…

A:

Q: Is the PEC a law? What is a small appliance branch circuit?

A: Small appliance branch circuit: This circuit is used for mainly in the kitchen area and not used for…

Q: Ro Cc loka Ce RL 2K Av nd = -3 CG - 0-01 MF C9s- 30 PF Find Au felMHZ

A: We need to find out gain at given frequency

Q: Q2. Obtain the output response y(n) of the below LTI system for the input x(n) = { 1 , -2, 1, 3 }…

A: We need to find out output for given input and system

Q: 4. Determine the current passing through the 7K ohm resistor 1k 2k 5V 3k -7k

A:

Q: The following voltages and line currents were measured to a 3-phase, 3-wire feeder serving a…

A: In this question,  We need to calculate the total power in the system?  We know power P= VI cos(V^I)…

Q: 5. E, = - R, = 52 R2 = 10 0 R3 =10 0 %3D T. R = 20 0 T = 6 A Rg = 20 2

A: Solve this circuit to find the equivalent resistance Using the given current find the voltage using…

Q: 4. A signal with power 7 mW is distorted by noise with power 0.002 mW. What is the signal to noise…

A: In this question,  We need to determine the SNR in the dB We know SNR is the ratio of signal power…

Q: Use Fourier transform

A:

Q: Apply node analysis to obtain V1 in the following circuit.

A:

Q: a capacitor for a capacitor-start copacitor-run motor is connected in _____ with the windings to…

A: The solution is given below

Q: Explain the effect of changing excitation (normal, under and over-excitation) on a synchronous motor…

A:

Q: For the following input circuit, determine the level of the input current in uA. Ry I ka z, Z, ^ 2…

A:

Q: An open–wire transmission line is made from two wires, each with a diameter of 2.5 mm, located 16 mm…

A: In this question we will write effect on characteristic impedance of open wire transmission line if…

Q: Find the line currents in the unbalanced three-phase circuit of Fig. 2 and the real power absorbed…

A:

Q: For the function f(a,b,c,d)=Em(1,3,4,5,6,7,10,12,13)+Ed(2,9,15), find all minimum sum-of-products…

A:

Q: In the circuit above:, the supply provides 3 V, the resistor is 1.66 kN, and the inductor is 13 mH.…

A: The solution is given below

Q: Use nodal method to find the branch currents l1, l2, 13, l4 and Is in the network shown below.

A: The given circuit is shown below,

Q: 22.Two resistors are connected in parallel to a 220 V line. R1=50 ohms and R2=100 ohms. How much…

A: The solution is given below

Q: (7)Using the method that applies the Laplace Transform to the circuit below. The switches in the…

A: Given the circuit, as shown below: We need to calculate V0(s) , vo(t) and i(t).

Q: R V = 12 V, V1 = 6 V Determine the maximum output voltage O 18 V O ov O 6V O 30 V

A:

Q: Q/ Using Kirchhoff's law, find the current ? R. =472 R:1502 12-2

A:

Q: A separately excited generator, when running at 1000 rpm supplied 200 A at 125 V. what will be load…

A:

Q: A So m aluminum wire has a ooss sectional area diameter oF 8. the conductivi vy or the wire- mm. It…

A: The solution is given below

Q: S1= 3020° Amperes S2 = 220 20° Volts USE MESH ANALYSIS to get: а. 11, 12, 13, b. lo c. V3 and P3…

A: The figure is as shown below, We need to find I1, I2, I3, Io, V3, and P3.

Q: Using nodal analysis, calculate the current dropped across each resistor, the node voltages (V1) and…

A:

Q: A - jjo00 -jioco -j250 L-j250 jioco З РHASE 0.5+j2 M B. 0.5+j2 -jiooo SOURCE AC -joo0 мотOR -j2so C…

A: Power factor: It tells how much active power is utilized by the circuit from the apparent power.

Q: Q3/ Determine if each of the following signals is a power signal, an energy signal, or neither. (a)…

A: We need to check whether the given signal are energy signal or power signal

Q: Find the input resistance, voltage gain, current gain, and power gain for the amplifier. Bpc= 250.…

A: We need to find out input impedance , current, voltage and power gain for given circuit

Q: of 0,0242 per phase and standstill etermine the speed at which maximum torque is developed. Ans[1440…

A:

Q: P5.86. Find the Thévenin and Norton equivalent cir- cuits for the circuit shown in Figure P5.86.…

A: In this question,  A circuit is given,  Find the Thevenin equivalent and Norton equivalent across…

Q: Find the following a) RT b) IT 10Ω 50 60 12 V 10Ω ww

A: Given circuit,

Q: What do all resistive-type loads convert electric energy into?

A: The solution is given below All resistive load has only resistance R. The R consumes only real power…

Q: deriv ds in Cylnderical deriv dv iin Cylnderical

A:

Q: How many calories are developed in 1.0 min in an electric heater which draws 5.0 A when connected to…

A: In this question,  We need to choose the correct option What is energy in calories if Voltage V=…

Q: = 15 V, V = 6 V termine the minimum voltage. -11 V -15 V -21 V 0-9V

A:

Q: Component values of the following circuit are listed in the Table I. Answer the following questions…

A: In this question,  We need to determine the value of voltage V2 as shown in the circuit .  We are…

Q: D1 Vsecondary Vfiltered D2 V1 sine Rload I 120 VAC @ 60 Hz D3 10:1 - D4 Figure 1: Bridge Rectifier…

A: We need to find out capacitor value for given filter voltage

Q: Vec Rc RB VE OE For the circuit shown above, assume Vcc- 12V, Ra 330KO, Rc- 1.5kO,B- 120. Determine…

A:

Q: Q/ Using Kirchhoff's law, find the voltages ? 150 T 5V 300

A:

Q: Find the Re(z) and Im(z) z=cosh[(3+i2)(1+i)]

A: The solution is given below

Q: Q5. The one-line diagram of a three-phase power system is shown in Figure 1. Select a common base of…

A: For a three phase power system, the one-line diagram is shown below, Common base on the generator…

Q: What is the area in circular mils

A:

Q: P3.15 Complete the timing diagram in Figure P3.15 for a positive edge- triggered JK flip-flop. K •…

A: In this question we need to complete the timing diagram of the given JK flip flop .

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.