Please answer in typing format For the given figure, v = 32/44°V. Find the average power absorber by the 102 resistor.402ww-7500.1V810j5Q10 Ω VThe average power absorber by the 102 resistor iskW (Calculate to 2 decimal places)

Answered: For the given figure, v = 32/44°V. Find…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter26: Three-phase Circuits

Section: Chapter Questions

Problem 3PA: You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a...

See similar textbooks

Similar questions

1. Find the average value of current when the current that are equidistant are 4A, 5A and 6A. a) 5A b) 6A c) 15A d) 10A
Calculate the value of RB in ohms. at VE=3V, RE=252 ohm, IB=20uA, RC=2637ohm and VCE=9V
Find the current I, given 0.1F 552 rele vlt) = 10 Sin(sot)
6. Determine the peak and average power delivered to RL in figure. 2:1 RL 220 N 120 V rms alll lelll
For the Photoflash unit. Vse 9V. RISKO C-1500 uf. R2= 120. The average power dissipated by the lamp is High voltage de supply 6.75W 8.3W 0.675W 10W 0.6W The mutual inductance sign for the following circuit is 352 www Negative R₂ Positive 2 mH 3 mH ell 5 mH www 10 Ω
A moving coil ammeter and a moving iron ammeter are connected in series with arectifier across 110V (r.m.s.) AC supply. The total resistance of the circuit in theconducting direction is 60 ohm and that in the reverse direction may be taken asinfinity. Assuming the waveform of the supply voltage to be sinusoidal, calculate thereadings in each ammeter
A series circuit consists of a 66.4 microfarad capacitor and variable resistor. For what two values of resistance will the power taken by the circuit be 172. 8 W, if the impressed 60 Hz emf is 120 V?
1. Determinewhether each diode in figure 1 is forward biased or reversed biased. 2. Determine the voltage across each diode in figure 1, assuming the practical diode.
Determine the DC currents (la. lc and I) and dc junction voltages (Var Ver and Vca) la-Blank 1 mA, le-Blank 2 mA, I-Blank 3 mA, Var Blank 4 V, Vcr Blank 5 V and VcB - Blank 6 V Use 2 decimal places. Use the following values. VBB= 3V RB= 5kOhms Rc=232 ohms Vcc =18 V BDC=65
A circuit having power factor of 0.8 consumes 40 W. What will be the value of reactive power of the circuit ?
8. Liquids with solid impurities a) Have higher dielectric strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average de voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
A solar panel has Voc = 21.5 V, Isc = 12 A/m. Fill factor is 70 %. Solar radiation is 900 W/m. Then the efficiency of the solar panel is Select one: O a. 0.6 O b. 18.06 9% O c. 73 9% O d. 20.06 96

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

For the given figure, v = 32/44°V. Find the average power absorber by the 102 resistor. 402 ww -750 0.1V 810 j5Q 10 Ω V The average power absorber by the 102 resistor is kW (Calculate to 2 decimal places)