Given the Specific Short term load foreceustingStrategy for three group of power Consumersincountry Using the Valender's modelP= K, Ê +KVE with it energy consumption andgiven coefficients below,Annual energyCustumergroupAomestick2Cousumphium0.292.5Flectric Spacehenting38,00 Mwh43,00 Mwh0:220.9Commercial1.9S1,00 Mwh0.25Determine the FollowingO The load demand forcasting for DamesticConsumevsDThe loud demand fircasting For Electvic SpaceHeating Consumery.9 The Specific load demand forcasting for CommenciadConsumevsO The total (P) load in the comantry with respetto the three classified loads. leaving your finulanswer in G i ga watts-

Given Load forecasting of three consumers P= power in watts E= Energy in watthour Valender's model…

Given the Specific Short term load forecusting Strategy for three group of power Consumers in a country Using the Valender's model P= k, Ê +KVE with it energy consumptim and given Co efficients below, Annual energy k2 Cousumphium Custumer group Aomestic 0.29 2.5 38,00MWH Flectric Space heating 0 22 H3.00 Mwh 0.9 Commercial 0.25 S1,ow Mwh Determine the Following The load demand forcasting for Domestic Consumevs The loud demand fircasting for Electvic Space Heating Consumers. The Specific load demand forcasting for CoNimievciad Consumevs O The total (P) load in the CoMntry with respect to the three classified loads. leaving your finud answer in Gi ga watts-

Given the Specific Short term load forecusting Strategy for three group of power Consumers in a country Using the Valender's model P= k, Ê +KVE with it energy consumptim and given Co efficients below, Annual energy k2 Cousumphium Custumer group Aomestic 0.29 2.5 38,00MWH Flectric Space heating 0 22 H3.00 Mwh 0.9 Commercial 0.25 S1,ow Mwh Determine the Following The load demand forcasting for Domestic Consumevs The loud demand fircasting for Electvic Space Heating Consumers. The Specific load demand forcasting for CoNimievciad Consumevs O The total (P) load in the CoMntry with respect to the three classified loads. leaving your finud answer in Gi ga watts-

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.14MCQ: The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load...

See similar textbooks

Similar questions

Driving-point admittance The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base Voltage is 600 V and Base Power is of O 6000 VA O 8000 VA O2000 VA 4000 VA Jump to ncements MacBook Air DD DII F10 F9 F8 000 F7 F6
Discuss the concept of reactive power and its role in grid stability.
The per unit impedance of a generator on a 60 MVA, 20 kV base is j0.09 p.u. The per unit impedance to a 100 MVA, 20 kV base will be (a.) j0.054 p.u. (c.) j 1.5 p.u. (b.) j0.54 p.u. (d.) j0.15 p.u.
Can ripple factors be grater then unity . Justify?
The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
For the maximum average power transfer in the circuit shown in Figure 2, use the impedance ZLand ZLFind the value of the maximum average power transferred to ? (Can you write the steps in detail in sentences?)
Hoover Dam has a nameplate capacity of 2080 MW[] and an annual generation averaging 4.2 TW·h. (The annual generation has varied between a high of 10.348 TW·h in 1984, and a low of 2.648 TW·h in 1956.) Determine the capacity factor. Ans. 23% (Show the Solutions)
21. The total power drawn by two-impedance load in parallel is 15kW at 85% power factor lagging, it's being supplied by 230- volts AC source. One of the loads (Load 1) takes 11KVA at 90% power factor leading. a. What is the real power, reactive power, and the apparent power of the unknown impedance (Load 2)? b. Find the resistance and the reactance of the other impedance load (Load 2). c. Determine the currents on each branch and the total current
A synchronous generator has been synchronized to an infinite grid of 13.8 kV and 60 Hz. The generator prime mover C/C is such that the no-load frequency is 62.5 Hz and the power slope is 1 MW/Hz. The AVR C/C (The reactive power against the terminal voltage C/C) is such that the zero reactive power voltage is 14.6 kV, while the slope is 0.4 MVAR/kV. Calculate: (a) the kVA loading of the generator and its power factor. (b) the settings of the prime mover and AVR such that the generator delivers 3 MW at 0.85 lagging power factor.
Define three cases on which real and reactive power flow gets affected. Draw the phasor diagrams of all three cases.
A generating station is to supply four regions of load whose peak loads are10 MW, 5 MW, 8 MW and 7 MW. The diversity factor at the station is 1-5 and the average annual load factor is 60%. Then the installed capacity is (25 to26)MW. O (24 to25)MW. O (23 to24)MW. O
In the system shown in Figure 1, the transformers are connected star-star with both star points grounded and the generators are connected in star with thier star points grounded. The system base is 15 MVA. The transformers all have reactances of 0.04 p.u. on this 15 MVA base. The reactances of all other elements are given in Table 1 (in 2) and the voltage levels are given in Table 2. p.u. G1 p.u. T1 jö Per-Unit Convert all values to p.u. on a 15 MVA base. Xa= p.u. Xc₂= XL = V BABE G1 2 X 9 T3 Figure 1: A section of the distribution system T1 L Table 1: Sequence reactances (2) 3 G1 L G2 0.3 0.59 0.01 4 L 9/10 10 Fault Voltage What is the voltage at bus 3 (in Volts) after the fault has occurred? Vp= V T2 5 T2 34 10/4 Table 2: Voltage bases (kV) G2 4 T3 10/9 | G2 Fault Current A three-phase fault with a fault reactance of 0.01 p.u. occurs at bus 3. Calculate the fault current flowing at the fault point in KA. Ip=-j KA So