In a 32-bit microprocessor, if any instantaneous PC (program counter), register value of the program is 0xFABB102D (this address is the command that is executed at that time), the PC shows what address value after 7 commands have been executed (run) on the processor.

Q: On a typical microprocessor, a distinct I/O address is used to refer to the I/O data reg- isters and…

A: There are two I/O instruction formats utilized in the Intel 8088. In one format, an 8-bit port…

Q: . A segment is an area of memory that includes up to - How large is a segment in the 8086? Can the…

A:

Q: Q1\ Suppose 8086 microprocessor perform the following task: ADD AX, 3FF2H Where the value of AX is…

A: Actually, 8086 is a 16 bit microprocessor.

Q: What are the characteristics of the difference between addressing odd addresses and even addresses…

A: Introduction: When a word is read from an unusual address, one byte is contained inside one word,…

Q: Pipelining in 8086 processors is achieved using which of the following option: O a. By using the…

A: Here have to determine correct option for 8086 pipeline.

Q: Let us know what you think about the performance of two address instructions versus one address…

A: Actually, given question regarding instruction formats. There are 4 instruction formats. 1) Zero…

Q: For this assignment, you are to write a MIPS assembly language program using the MARS IDE and assume…

A: Answer :

Q: The IA64 processors contain registers that can be used to address a 64-bit address space. However,…

A: The question is: The IA64 processors contain registers that can be used to address a 64-bit address…

Q: CPU Datapath The following figure shows the overall datapath of the simple 5-stage CPU we have…

A: ANSWER: a) MUX 1 Input 1: Register A input 2:Register B b) MUX 2 Input 1: Register C input…

Q: A process occupies a computer's main memory locations starting at address 76524. What is the logical…

A: Defined the given statement

Q: 23)The last action taken by the CPU in the fetch-execution cycle is: a. IR[address] --> MAR b. PC +…

A: Here, we are asked the last action taken by the CPU in the fetch-execution cycle is. During…

Q: 9.) A 8255 PPIO circuit is connected to system bus of the 8085 microprocessor. The base address of…

A: In this 8085 program initially, 8255 is being set up in I/O mode. Then FF hex (i.e. 1111 1111…

Q: memory addresses are two different Instead of putting the whole data in memory, use memory as a…

A: The CPU interacts  closely with primary storage, or main memory, referring to it both instructions…

Q: How can we use a relocation register to move a logical address to a physical address?

A: Intro As per the question, we need to determine how we can relocate a logical address to a physical…

Q: The MIPS assembly language command: add $t0, $s1, $s2 when converted to machine language code looks…

A: Please upvote/like. Please. I need it badly. I am providing you the correct answer below.   This is…

Q: 1- Memory locations can be addressed by a microprocessor with 14 address lines? 2- Chips are…

A: 8086 System 8086 Microprocessor is an advanced version of the before version of 8086 which is teh…

Q: A program accesses ten continuous memory locations. The CPU will take less time if the addressing…

A: Defined the given sentence

Q: Assume that an interrupt mechanism uses the hardware stack to store PC and other registers of the…

A: Interrupts: these are the signals which will be sent to the central processing unit by the…

Q: How many bus cycles are required to transfer a trouble word

A: There are at least four clock periods in a bus cycle of 8086 microprocessor. These four clock…

Q: What is the size of the memory for the microprocessor if it has 24-bit address lines (bus)?…

A: Answer for your ques is given below:

Q: Q1/ Explain with details the segments memory of microprocessor 8086 at below action: 1- Fetch and…

A: Bus: A bus is a common group of wires that interconnect components in a computer system. The buses…

Q: When an interrupt occurs, which of these functions would be the last to occur? O a. the processor…

A: The stack is an SRAM area that is used to store the general registers temporarily. An operation…

Q: 8051 microcontroller embedded systems question   a.       LCALL is a ……………….byte instruction. b.…

A: 80851 instruction byte for different call of instruction

Q: Given the following memory values and a one-address machine with an accumulator,what values do the…

A: Given the following memory values and a one-address machine with an accumulator, Word 20 contains…

Q: Most machines can replicate data in both directions, from and to another register. The Memory…

A: In a PC, the memory address register (MAR) is the CPU register that either stores the memory address…

Q: a- Write the codes used for segments (of 8086 microprocessor) designation in machine language…

A: segment .text    ;code segment   global _start    ;must be declared for linker  _start:…

Q: Example 1: Write a program to move a data from Accumulator to register P1 ; Return to Monitor…

A: We need to write a assembly program that move a data from accumulator to register p1.

Q: The PC is incremented so that during the next instruction cycle, the next instruction will be…

A: The PC is incremented so that during the next instruction cycle,the next instruction will be…

Q: uppose, a word-wide input device (i.e. each input is 2 bytes in size) is connected to the port of an…

A: Answer: I have done code  and also I have attached code as well as code screen shot.

Q: 21 - In the microprocessor, the leftmost 3 bits of the 14-bit address bus are reserved for Chip…

A: Given: leftmost 3 bits of the 14-bit address address bus contains 2FBAH  find the selected device ID

Q: The ARM CPU described above is used to execture the following piece of ARM machine code, loaded into…

A: Answer: I have given answer in the brief explanation.

Q: microprocessor 8086/8088 which one and how ?   Assume the content of the segment register ES =…

A: microprocessor 8086/8088 which one and how ?   Assume the content of the segment register ES = ACEE…

Q: 2. Given the following series of instructions (left two columns). After each instruction has been…

A: In computer engineering, computer architecture is a set of rules and methods that describe the…

Q: ( Please solve the question using the program emu8086.......) Write the assembly code to find the…

A: The code would be as follows: - 2000 CLD : Clears the direction flag - 2001 MOV DS, 2100 H : In the…

Q: in a certain microcomputer system, the microprocessor is connected to an external memory of size…

A: In a certain microcomputer system, the microprocessor is connected to an external memory of size…

Q: After the instruction Idr ro, [r1] is executed, what is the content of ro? A. The 8-bit value…

A: content of r0 after the instruction executed

Q: Suppose a program’s 15-th logical instruction (counting starts from zeroth) is at physical address…

A: Dear Student, Assuming the Addresses are byte addressable thus 14 th byte address will be at…

Q: Q1\ Suppose 8086 microprocessor perform the following task: ADD AX, 3FF2H Where the value of AX is…

A: The flag register has following: Status Flag Sign (S) Parity (P) Zero (Z) Overflow (O) Auxiliary…

Q: between the address

A: Step 1: The pins' names give you a hint.The 8088's eight lowest-order pins are referred to as…

Q: What is the highest and the lowest address in the 8086’s memory address? Is memory in the 8086…

A: In this question, we are going to address about 8086 microprocessor

Q: The table below shows a segment of primary memory from a Von Neumann model computer Address Data…

A: Answer This is The flow of instruction execution MAR<-- PC MBR<--Memory[MAR] PC=PC+1 IR<--…

Q: Suppose that a 32MB system memory is built from 32 1MB RAM chips. How many address lines are needed…

A: As it is given that there are 32 RAM memory chips. To represent 32 different binary numbers we…

Q: For the 8086 microprocessor, show the physical addresses and the contents of memory after execution…

A: The DW,DD and DB are data declaration directives 1. DW: Directive used to declare Word type…

Q: 2. Given the following series of instructions (left two columns). After each instruction has been…

A: Register 4= contains the value of M6Register 5= contains value of M5

Q: If a microprocessor has a 24 address lines and 16 data lines, then the memory address space of this…

A: Given address lines=24 Data lines=16

Q: Segment registers are:Select one: a. Define the logical address b. All the given options here C c.…

A: 1. Segment registers are: option b) is correct As segment registers define the logical address.…

Q: computer is available without an instruction pointer (IP) or program counter (PC). Instead, all…

A: ANSWER : A)  MEMORY WORD CONSISTS  256K, PRE EACH WORD CONSISTS 32 BIT ACOORDING TO BASIC OF OUR…

Q: Draw the complete block diagram for an 8086 Microprocessor system with two PPIs, where the address…

A: Block Diagram of 8086 Microprocessor with PPIs The architecture of 8086 microprocessor is composed…

Embedded Software Development

Using specific programming languages (like C and C++) to write code for a specific hardware device in which it runs is called embedded software development. It makes the device smart by performing actions based on user's input which improves the user experience. They are designed to perform function-specific tasks rather than doing multiple tasks like computers. The embedded system is incredibly intuitive. An embedded software system could be a system developed and organized on any device, apart from an old-fashioned computer. It is the brain of a specific device; however, it is a solely useless tool and simple to elucidate what software system is embedded.