inserted into a tank that contains a fluid with a density of 1.35, as shown in the figure. The natural gas tank weighs 94N. Determine: a) h value b) the force necessary to hold the tank as shown in the figure

Q: With such a velocity of 120 m/s, air at 350K and 5x105 Pa enters a 1-in schedule 40 (ID = 1.049)…

A:

Q: Alumium alloys is used for packaging and food containers, because it is --- alloys. O low density…

A: identify the property of aluminium allow for pakaging and food container.

Q: A 20 mm diameter bet having a diameter at the toot ef the thread of 18.6 mm is used to fasten two…

A:

Q: 1. Plot the four locations in the psychrometric chart and determine the other properties for each…

A: As per our guidelines we are supposed to answer only one question. Kindly repost other questions as…

Q: Problem 2: It is recommended to change the circular cross section shown in the figure by a square…

A: Given data :- maximum shear stress in both sections is same . find the dimension of square section .

Q: Multiple Evaporator Systems it may be required to

A: Solution-  Option C is correct, have different temp. Maintained at special zones.

Q: 2. Compute the equivalent resultant force and moment for the system of forces and couple shown in…

A: find the equivalent resultant force and moment about 'o'.

Q: For a 8-node quadrilateral element, with an Aspect Ratio AR=1 and an element size of 1mm, find the…

A:

Q: For the cantilever beam shown. find the value of compound stresses at :point C due to Normal…

A:

Q: 4. Determine the horizontal and vertical components of reaction at the pin A and the tension…

A:

Q: When 20 N of force is applied to a spring of natural length 2 m, the resulting compression is 0.5 m.…

A: Given data :- force = 20kN natural length = 2 m compression = 0.5 m find the spring constant.

Q: Determine the damping constant of the dashpot as shown in the figure. The dashpot consists of a…

A:

Q: 15KM. B. 6m 3m. Determine the force iñ each member and state Wha thir it is iñ tenrim or…

A: GIVEN DATA- A PLANE TRUSS GIVEN WE HAVE TO FIND FORCE IN ALL MEMBER

Q: In a Rankine cycle, saturated liquid water at 1 bar is compressed isentropically to 150 bar. First…

A: Given data Cycle : Rankine Superheated cycle Turbine entry conditions : 150 bar and 750 K Condenser…

Q: An Otto cycle has a compression ratio of 7.5. Determine the volume at the end of expansion if the…

A:

Q: A pipe contains an oil of specific gravity 0.8. A differenti- manometer connected at the two points,…

A:

Q: At 300 degrees Celsius and 1 atmosphere, air moves at 0.9 times the speed of sound. The specific…

A: GivenT1=300oC=573KP=1atm=101.325KPaVair=0.9×Vsoundγ=1.4

Q: Solve for the laplace transform using the formula. F(t) = e-2t-5

A:

Q: Q5: How is the surface quality improved in ball burnishing?

A: This question is based on the concept of ball burnishing from manufacturing engineering.

Q: You have been asked to cook a 6 kg joint of beef in a conventional oven preheated to 200°C. The…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: The engine generates electrical power at 1MW. At 500°C a temperature of 1.5MW heat is sent from the…

A: heat rejected = heat supplied - workdone = 0.5 MW

Q: R3) The circular disk rolls without slipping. Determine the velocity of points A, B, C and P A @= 4…

A:

Q: 1. Determine the horizontal and vertical components of reaction at the supports. Neglect the…

A:

Q: what is the unit of the medium resistance and the specific cake resistance

A: Given Resistance To find Unit of Cake resistance Unit of Medium resistance

Q: A rigid bar, hinged at one end, is supported by two identical springs as shown in figure below. Ea…

A:

Q: What is the size of the stiffness matrix of a 4-node quadrilateral element?

A: Size is 8×8 matrix

Q: Ductile cast iron is also known as iron. O cluster O flakes cementite O nodular

A: Ductile iron is also known as, spheroidal or nodular iron.

Q: A car has an initial speed of 17m/s and a constant deceleration of 1 m/s². Determine the velocity of…

A:

Q: A superhero tries to move a massive odd-shaped boulder. The boulder can be considered a composite…

A:

Q: e a planet rises, and cool material sinks towards the center. nergy throughout the Earth's core.…

A: 1 correct answer is options c In conversation medium is required for the heat transfer

Q: Draw the shear and bending- moment diagrams for the beam and loading shown, and determine the…

A:

Q: Example :- Calculate the power in W/m³ required for mixing an oil of relative density 0.93 and…

A:

Q: The 10-lb block A travels to the right at va = 3.1ft/s at the instant shown. I the coefficient of…

A:

Q: b) Determine the support reactions for the following member. [AB= BC =CD = DE = 5 ft] %3D 15 lb/ft A…

A: Given data :- AB= BC = CD = DE = 5 ft. find the reactions at the support.

Q: Determine the resultant of the line load acting on the beam ABC. 1200 Ib/ft y 1700 Ib/ft C 6 ft -8…

A: find the resultant force of the given distributed load.

Q: Home / Chapter 8: Bending / M8.1: The Centroids Game - Learning the Ropes The Centroids Game -…

A: find the centroid of the section and fill the table .

Q: Multiple Evaporator Systems it may be required to have different temperature maintained at single…

A: Correct answer: (B)

Q: steam power plant of 40% thermal efficiency receives heat of 150 MJ at nigh temperature while…

A: Given data :- efficiency = 40 MJ heat received = 150 MJ work supplied by the pump = 10 MJ determine…

Q: Hello, i have to find the carbon footprint of the otto cycle, can you help me?

A: INTRODUCTION: The petrol engine work under the Otto cycle, the Otto cycle has four phases that…

Q: 6.22 This planar water jet (60°F) is deflected by a fixed vane. What are the x- and y-components of…

A:

Q: The crank AB in the following mechanism rotates clockwise at 8 rad/s, determine the velocities of…

A:

Q: A cylindrical tank of radius 5 ft and height 9 ft is two-thirds filled with a liquid of weight…

A: Given   Radius, R = 5 ft  Height, h = 9 ft     Density = 1000 kg/m3 Find  Weight density, w

Q: A simple saturation cycle using ammonia between pressures of 10 psia and 165 psia…

A:

Q: Find the equivalent translational mass at location A of the system shown in the figure. Please also…

A:

Q: The state of stress at a point for a given reference xyz is given by the following array of terms :…

A: For a particular reference, we know the condition of stress at a specific moment. The following…

Q: Q3. For a closed end cylinder where the inner radius is 20 mm and outer radius is 40 mm, and the…

A: Given        Pressure, P = 5 MPa   Inner radius, r = 20 mm Outer radius, R = 40 mm      Thickness, t…

Q: Show the P-h diagram and your solutions. 1. A simple vapor compression cycle using R-134 refrigerant…

A:

Q: Q1: How is the size of the abrasive grain chosen?

A:

Q: A uniform circular thin rod of radius 10 in. is attached to a pin at C and to the cable AB. Find the…

A:

Q: A pipe contains an oil of specific gravity 0.8. A dliferenual manometer connected at the two points,…

A: