Problem 2. Reynolds Transport Theorem. kir with a density of 0.0644 Ib.-m./cu. ft is flowing upward in the vertical duct, as shown. The velocity at he inlet (station 1) is 80 ft/sec. The area ratio between stations 1 and 2 is 0.5 A2/A1 = 0.5). Two pressure taps, 10 ft apart, are connected to a manometer, as shown. The specific veight of the manometer liquid is 120 Ib.f./cu. ft. Find the deflection, Ah, of the manometer. Note:1 slug = 32.2 lb.-m., and to convert slugs to Ib.-f., multiply by 32.2 ft/s^2. Acceleration due to gravity, g= 32.2 ft/s^2. 10 ft

Problem 2. Reynolds Transport Theorem. kir with a density of 0.0644 Ib.-m./cu. ft is flowing upward in the vertical duct, as shown. The velocity at he inlet (station 1) is 80 ft/sec. The area ratio between stations 1 and 2 is 0.5 A2/A1 = 0.5). Two pressure taps, 10 ft apart, are connected to a manometer, as shown. The specific veight of the manometer liquid is 120 Ib.f./cu. ft. Find the deflection, Ah, of the manometer. Note:1 slug = 32.2 lb.-m., and to convert slugs to Ib.-f., multiply by 32.2 ft/s^2. Acceleration due to gravity, g= 32.2 ft/s^2. 10 ft

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Problem 4. (20pts) Two vessels are attached to an inverted U-tube containing air at 23 psi and 70°F. If vessel A contains water that rises in the tube at 85 inches and vesselB contains glycerin, determine the difference in pressure (psf) between vessels A and B and the absolute pressure at point B (inHg). Given that the atmospheric pressure is 14.6 psia and y is 16 inches. SGgycarin 1.26, B dveerin S-1.26
1. A horizontal venturimeter with inlet diameter of 200 mm and throat diameter of 100 mm is used to measure the flow of oil with specific gravity of 0.9. The discharge of oil through the venturimeter is 35 L/s, find the reading of the oil-mercury differential manometer. Coefficient of venturimeter is 0.97 and specific gravity of mercury is 13.6. 2. The pressure difference measured by the two tappings of a pitot-static tube, one pointing upstream and the other perpendicular to the flow, placed in the center of a pipe line of diameter 300 mm is 120 mm of water. The mean velocity in the pipe is 0.7 times the central velocity. Find the discharge through the pipe. Coefficient of the pitot tube is 0.96.
Oil (SG=0.8) discharges from a 250mm diameter pipe through a sharp-crested orifice whose diameter is 65mm. The coefficient of contraction and velocity are 0.62 and 0.98, respectively. The manometer pressure reading at the pipe is 16.7kPa. Calculate the discharge through the orifice. O 0.193 cu.m./s O 0.021 cu.m./s O 0.318 cu.m./s O 0.013 cu.m./s
A cylinder is placed in a steady water flow as shown. Calculate the pressure difference PB - PA in psi if the flow speed at A is 10 ft/sec. .A O 1.04 O 1.53 0.67 1.92 0.82 O 1.74
For the pipe enlargement shown, the pressure at sections (1) and (2) are 56.3 and 58.2 psi, respectively. Determine (Gasoline density=1.32 slug/ft³) a. The Velocities at section 1 and section 2. b. The flow rate (Q) of the gasoline in the pipe. 2.05 in. (1) Gasoline 3.71 in.
A venturi meter with a throat diameter of 100 mm is fitted in the inclined pipeline of 200 mm diameter with oil of specific gravity 0.88 flowing upwards. The venturi meter coefficient is 0.96. Two pressure gauges are fitted at tapping points, one at the throat reads the vacuum pressure of 40 cm of mercury and the other in the inlet pipe 320 mm below the throat is 20.231 N/cm2. If the loss of head in the main and throat is 0.35 times the kinetic head of the pipe, determine2.1 the volume flow rate of oil through the pipe2.2 the difference in level in the two limbs of the mercury manometer if it is connected to the tapping points and connecting pipes are filled with the same oil
Figure Q1 (a) shows the tank attached with piezometer tubes. The pressure gauge A is 2.3 kPa. The specific weight for the air is 12.0 N/m', the specific weight for gasoline is 6670 N/m³ and the specific weight for the glycerin is 12360 N/m³. Find the elevation level, ZB and Zc of the liquid (in meters) in the open piezometer tubes B and C. A B C 2 m Air 1.5 m Gasoline ZB Zc 1 m Glycerin Figure Q1 (a)
Gasoline having a specific gravity of 0.8 is flowing in the pipe shown at a rate of 5 cfs. What is the pressure at section 2 when the pressure at section 1 is 18 psig and the head loss is 9 ft between the two sections? Assume a = 1.0 at all locations. A₁ = 0.80 ft² O 30.6 psia O 2592.0 psia O 2286.6 psia 15.9 psia Vertical 12 ft A₂ = 0.20 ft²
A Venturimeter having a diameter of 75 mm at the throat and 150 mm diameter at the enlarged end is installed in a horizontal pipeline 150 mm diameter carrying an oil of specific gravity 0.9. The difference in pressure head between the enlarged end and the throat recorded by a U-tube manometer is 175 mm of mercury. Determine the discharge through the pipe. Assume the coefficient of discharge of the meter is 0.97.
0.12 O -0.12 8.33 (1) Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two piezometers separated a distance, L. Given the set-up shown, determine the hydraulic gradient if the hydraulic head at (1) is 66 cm, hydraulic head at (2) is 54 cm, and the travel distance is 100 cm. O-8.33 -L h e - - - -
Compute the pressure @ point n ( Pn ) as shown by the differential manometer in KPa if pressure @ point m ( Pm ) is equal 1027.66 mm Hg. air plpeline where: a= 12" b=3,2 C-4.0 d- 12 m mercury density (16 300 kghm) water pipeline
Distilled water at 10deg C stands in a glass tube of 9.0 mm diameter at a height of 24.00 mm. What is the true static height in mm if the surface tesnsion is 0.0742 N/m. CHOICES: a.24 mm b.27.4 mm c.3.4 mm d.20.6 mm