The 14-kg block is held at rest on the smooth inclinedplane by the stop block at A.(Figure 1)Figure1 of 130 Part AIf the 10-g bullet is traveling at 270 m/s when it becomes embedded in the 14-kg block, determine the distance theblock will slide up along the plane before momentarily stopping.Express your answer using three significant figures and include the appropriate units.ValueUnitsSubmitRequest Answer

Answered: Image /qna-images/answer/293f1c53-753a-4fe0-a767-3655e74dc662.jpg

Answered: The 14-kg block is held at rest on the…

Engineering

Mechanical Engineering

The 14-kg block is held at rest on the smooth inclined plane by the stop block at A. (Figure 1)

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.21P: The 1200-lb homogeneous block is placed on rollers and pushed up the 10 incline at constant speed....

See similar textbooks

Related questions

Q: Problem: Determine F to keep the block at rest. 500 kN IS 30

A: Given: A block of weight 500 kN is resting on a inclined plane, which makes an angle of 300 with…

Q: A rope of negligible mass passes over a pulley of negligible mass attached to the ceiling, as shown…

A: Given:

Q: W 300 lb P. 30

A: W=300 lb Horizontal force ∑Fx=0-Wsin30+Pcos45=0......1∑Fy=0Psin45+N=wcos30..........2

Q: Figure 1 of 1 A 6 in. 4 in. kg = 200 lb/in. B kc = 100 lb/in.

A: Given Data: Mass of the block A, m=48 lb

Q: Example: The floor crane and the driver have a total weight of 2500 Ib with a center of gravity at…

Q: The unstretched length of spring AB is 3 m. If the block is held in the equilibrium position shown,…

Q: A light rod is being used as a lever as shown. The fulcrum is 1.20 m from the load and 2.40 m from…

Q: 1. A boy stands out at the end of the diving board, which is supported by two springs A and B, each…

Q: A B -1 ft- 4 ft +1 ft-

A: We have to find normal force

Q: B 1.5 m F -2 m D.

Q: The smooth disks D and E have a weight of 200 lb and 100 lb, respectively. Determine also the…

A: A reaction force opposes an action force by acting in the opposite direction. During sliding,…

Q: Determine whether the block shown is in equilibrium and find the magnitude and direction of the…

Q: Activity 2. The coefficient of friction for all surfaces in contact is 0.25. Determine the minimum…

Q: The man pushes The wheelbarrow at a steady speed with a force P= 150 N, which is parallel to the…

Q: THE BARS AB AND AC ARE JÕINED BY A PIN AT A AND A HORIZONTAL CABLE. THE VERTICAL CABLE CARRYING THE…

A: Given:- m=200 kg B= pinned joint C= Roller joint To find:- To find tension in horizontal cable

Q: A puck weighs 10 lb and rests on the center of the frictionless surface of the ramp supported in…

Q: A small wedge is placed under the corner B of the 4000 kg block of marble. Determine the maximum…

Q: The smooth disks D and E have a weight of 200 lb and 100 lb, respectively. a. Determine the largest…

Q: A fixed crane has a mass of 1000 kg and is used to lift a 2400 kg crate. It is held in place by a…

A: Given data:

Q: minimum weight of W to prevent impending motion of the 400 N body down the plane.

A: Given: W1= 400 N W2= W μ = 0.25 To find : Minimum weight W to prevent impending motion of block…

Q: Given problem: A cylinder having a mass of 268.6 kg is to be supported by the cord which wraps over…

A: Given data Mass of cylinder = 268.6 kgCoefficient of friction = 0.2We have to determine the maximum…

Q: Determine the force in cable BA and BC needed to hold the 68-kg pipe.

Q: Static problem The 200-lb block rests on an inclined plane. The coefficient of friction between the…

Q: determine the force P necessary to start the V-shaped wedge

A: Given: The minimum force P require to move the V wedge in rightward direction

Q: The two blocks shown are originally at rest. Neglecting the masses of determine the tension in the…

Q: (b) In figure, the two weights are released from rest. The coefficient of kinetic friction between…

A: coefficient of friction = 0.18 find the tension in cable.

Q: The man pushes the 60-kg homogeneous crate with the horizontal force P. Determine the largest…

Q: The body A with a mass of 50 kg is in equilibrium with the help of the pulling force generated in…

A: Given data, Mass of body A, mA = 50 Kg Coordinates of point B = (10, 6, 0) Coordinates of point C =…

Q: (b) In figure, the two weights are released from rest. The coefficient of kinetic friction = 0.18.…

Q: The two blocks started at rest. The surface of the inclined plane is frictionless. (note: neglect…

A: Given:WA=300 lbWB=400 lb

Q: 11.) In the figure shown, if u = 0.30 under both blocks and A weighs 400 lb, find the maximum weight…

Q: o raise and lower the 580-kg bucket i uired to slow the descent of the buch ble.

Q: The 3-kg block B and 17-kg cylinder A are connected to a light cord that passes through a hole in…

Q: Aroller of weight 500 N has a radius of 120 mm and is pulled over a step of height 60 mm by a…

Q: Q2: The pendulum consists of a 15 kg sphere and a thin bar of 5 kg. Calculate the reaction on pin O…

A: To find: The reaction at O just after the rope is cut. Given: The mass of sphere is M=15 kg. The…

Q: The supporting structure of the billboard is attached to the ground by a pin at B, and a roller at…

A: Given data: The weight of billboard and structure together is, W=1400 N. The mass of the weight is,…

Q: Problem 01: The 40-kg crate shown below rests o kinetic friction is Uk = 0.25. If the crat:…

Q: Determine the force P required to maintain the 240-kg engine in the position for which = 26°. The…

Q: A puck weighs 8 lb and rests on the center of the frictionless surface of the ramp supported in…

Q: The man pushes the 120-lb homogeneous crate with the horizontal force P. Determine the largest…

A: given data weight of crate (W) = 120 lb coefficient of friction (μs) = 0.4 To determine The…

Q: A 10-kg cabinet is mounted on casters that slides with a coefficient of friction of 0.2 (neglect the…

A: Draw the free body diagram of the cabinet.

Q: In the figure, determine the maximum weight of body B that will permit the homogenous 50-lb block A…

A: Given data as per question Mas of block A =50 lb ∑Fy=0w=N=50lb∑Fx=0T−F=0T−μN=0T−0.3(50)=0T=15 lb

Q: Block B is on top of an inclined plane and is being supported by Rod AB, which is attached to Block…

A: Given Blocks under tension with a rod To find Magnitude of normal of the blocks

Q: The winch cable on a tow truck is subjected to a force of T = 8 kN when the cable is directed at =…

A: T=8kN

Question

The 14-kg block is held at rest on the smooth inclined
plane by the stop block at A.
(Figure 1)
Figure
1 of 1
30

Part A
If the 10-g bullet is traveling at 270 m/s when it becomes embedded in the 14-kg block, determine the distance the
block will slide up along the plane before momentarily stopping.
Express your answer using three significant figures and include the appropriate units.
Value
Units
Submit
Request Answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Determine the largest angle for which the homogeneous block remains at rest.
The man pushes the 120-lb homogeneous crate with the horizontal force P. Determine the largest distance h for which the crate will slide without tipping.
The 40-lb spool is suspended from the hanger GA and rests against a vertical wall. The center of gravity of the spool is at G and the weight of the hanger is negligible. The wire wound around the hub of the spool is extracted by pulling its end with the force P. If the coefficient of static friction between the spool and the wall is 0.25, determine the smallest P that will extract the wire.
Find the stable equilibrium position of the system described in Prob. 10.56 if m = 2.06 kg.
The 80-kg crate has its center of gravity at G. Determine the smallest force P that will initiate motion if =35.
The homogeneous plate of weight W is supported by a ball-and-socket joint at D and three wires. Draw the FBD of the plate and count the unknowns.
The homogeneous 240-lb bar is supported by a rough horizontal surface at A, a smooth vertical surface at B, and the cable BC. Draw the FBD of the bar and count the unknowns.
The 400-kg drum is held by tongs of negligible mass. Determine the magnitude of the contact force between the drum and the tongs at D.
One end of cable AB is fixed, whereas the other end passes over a smooth pulley at B. If the mass of the cable is 1.2 kg/m and the sag is H = 1.6 m, determine the mass M that is attached to the free end of. the cable.
Determine the smallest horizontal force P that would push the homogeneous cylinder of weight W over the curb. Neglect friction.
Calculate the force P that is required to hold the 120-lb roller at rest on the rough incline.
The 1200-lb homogeneous block is placed on rollers and pushed up the 10 incline at constant speed. Determine the force P and the roller reactions at A and B.