What is the real power, reactive power and complex power delivered by the source in the given circuit? Current source is 10, angle 30 degrees A. What is the real power, reactive power and complex power delivered by the source inthe given circuit? Current source is 10, angle 30 degrees A.3Ω j4Ω5Ω+-j2 2

The solution can be achieved as follows.

Answered: What is the real power, reactive power…

What is the real power, reactive power and complex power delivered by the source in the given circuit? Current source is 10, angle 30 degrees A.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: Given a parallel impedance and resistor with a source emf of 220V, ZR =10Z0º 2, Z =4+j3, and Zc=6-…

Q: sinco so l0d) ideal transformer M:05 Vi amplitnate is Sovi icoHz. Li=0.4H Lo=o.5H tind VR, in time…

A: The ideal transformer in the above figure is converted into the T- circuit model

Q: 8. A series circuit with a resistor of 100 2 capacitor of 25 µF and inductance or 0.15 H is…

Q: A given load takes 40 KVA at 50% lagging power factor, while another load connected in parallel…

A: In this question we need to find the apparent power of the combined load.

Q: Q4 For the series R-L-C circuit of Figure Q4: (i) Calculate the total impedance Zr for the…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: 13. What is the value of reactive power, if the angle between star connected three phase 415 V a.c…

A: Given, Star connected three phase ac supply has, Line voltage, VL=415 V. Line current, IL=5.2 A.…

Q: The total power absorbed by a certain 3-phase load is 60 kW, the reactive power being 100 kVAR. Find…

A: Given,For a 3-phase load,Absorbed power, Pab=60kWandReactive power, Pre=100 kVAR

Q: A single phase lagging power factor load takes 300 W and 5 A at 120 V. Find the reactance of a pure…

Q: . The following information is given in connection with the circuit shown below: Za = 6 - j7.5 N; Zb…

Q: In the circuit in the figure; L1 load draws 15 kVA with lagging power factor 0.6. The L2 load draws…

Q: Question 6 Vs 20020°V L L S. rms In the circuit in the figure; Lload draws 15 kVA with lagging power…

Q: 62 Find power factor of given circuit ww- 30/0° V rms

Q: An R-L series circuit has a power factor of 73%. If the apparent power is 560 kVA, what is the…

A: There are 3 types of power in electrical - 1) Active power or true power - P=VI Cos∅ Unit is Watts…

Q: 2. For the circuit given in figure 6, find V_ rms and Lms on R3. R, R3 ww 10 20 R2 R4 5 Vp Figure 6

Q: In three phase power measurement, current coil is connected in series and potential coil is…

A: In three phase power measurement (wattmeter) consists of a current coil connected in series with…

Q: 4. In the single power system to the right, find the complex power S supplied by the Zc = - j0.2 Z =…

A: To find the complex power S supplied by the source

Q: A given load takes 40 kVA at 50 % lagging power factor while another load connected in parallel…

Q: e phase angle of the complex power is negative, then the circuit is said to be resistive. elect one:…

A: In this question we will find circuit nature if complex power phase angle is negative...

Q: S. 20020°V L ms In the circuit in the figure; • L1 load draws 15 kVA with lagging power factor 0.6.…

A: From the complex power

Q: Complete Solution: A 250 - kVA, 0.5 lagging power factor load is connected in parallel to a 180 - W,…

Q: Two impedances consist of resistance of (15 ohms and series connected inductance of 0.04 henry) and…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: The following conditions apply to the circuit in the figure. Find the complex power delivered to the…

Q: Two loads are connected to your standard AC power outlet (110v, 60H2). The first load has a 60%…

Q: Examole II. 9 Vm

A: To find real reactive and Apparent power supplied by source

Q: The three loads in the circuit can be described as follows: Load 1 is a…

A: According to question:…

Q: Two loads are connected in parallel to in e-c source and tako currents of 10 and 40 cunp,…

Q: Two impedances are fed by a source with V = 100Vrms 160 °, as shown below. The total current is I =…

A: In this question we will find currents, impedances ,power factor....

Q: 2. Three impedances (2 + j4), (3 - j5) and (1 – j3) are connected in paralel. The combination is…

Q: For the ac network of Figure Q5, calculate the following; L The total impedance; i. The inductance…

Q: 12. A resistance, inductance and a capacitance of 120uF are connected in series. When the voltage…

Q: In the circuit shown in figure beside, (i=5+20sin1000t+ 10sin2000t+5sin3000t) Amp. Wnte the…

Q: Determine the total impedance, total current and the power factor of the circuit shown in figure 2.…

Q: Two impedances Z1 = 2+j4 & Z2 =R are connected in parallel. Find value of R so that power factor of…

A: Given impedances and power factor are - Z1=2+j4Z2=Rcosϕ=0.9Lagging Given that impedances are in…

Q: The voltage across and current through the load in the figure are v(t) = 150cos(@t -45°) V i(t) =…

Q: In the circuit in the figure; L1 load draws 15 kVA with lagging power factor 0.6. The L2 load…

Q: circuit in the figure: A) the impedance seen when viewed from the source B) Flow C) Phase angle…

Q: Power factor adjustment minimizes. power in the circuit, allowing the large percentage of the power…

Q: Consider a sinusoidal emf source, v(t) = Vm sin (@t) results of current of i(t) = Im sin (@t+0) is…

Q: (e) Figure Q1(e) shows a two-branch parallel circuit. I 10 L-50° A Vs - 100 L-30° V z, 4 + j5 N w -…

A: Obtain the total current taken from the source then find the power using following relation Power S…

Q: What is the type of its power factor?

Q: A source delivers 50-kVA to a load with a power factor of 65percent lagging. Find the load’s average…

A: The fraction of complicated power that belongs to energy storage and retrieval rather than…

Q: A resistance of 20 ohm and a coil of inductance 31.8 mH and negligible resistance are connected in…

A: A) The inductive reactance of the circuit is, XL=jωLXL=j×2π×50×31.8×10-3 ΩXL=j10 Ω The impedance of…

Q: A given circuit has a resistor (R=20 ohms) and an inductor (L=0.3 henrys) connected in series…

Q: 9. Find the total power in a delta connected load with 6+j8 ohms per phase and supplied from a 220V,…

A: Note :- As per guidelines we are supposed to answer only one question. So I request you to post…

Q: In three phase power measurement, current coil is connected in series and potential coil is…

A: We know that Electrical power is measured with a wattmeter. A wattmeter consists of a current coil…

Q: Q: For the network in the figure bellow: a. Find the total impedance of the circuit. b. Compute the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: When connecting the circuit in the figure to an AC voltage generator, it is possible to say that L O…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: 100 A 220 V 50 Hz 0.138 H f(x) = 0 90 ohm Solver Configuration Electrical Reference

Q: (b) An inductive load consisting of resistor, R and inductor, L in series feeding from a 240230°…

Q: Two impedance Z, = 2+j3 and Z, = 3 +j6, are connected in parallel. The apparent power of the second…

Question

What is the real power, reactive power and complex power delivered by the source in the given circuit? Current source is 10, angle 30 degrees A.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A solenoid with an inductance of 0.25 H and a resistance of 100 Q is connected to a 120-V 60-Hz source. The current is: Please check the closest answer that applies. X L 120 V 60 Hz O0.226 2-16.3° A O0.224 2-31.2° A LO
5 The voltmeters in the figure measure RMS voltages. If V, = 23 V and V, = 14.5V what is V3? %3D C R eee V2 V3 23 V None of them 8.5 V 4.5V 37.5 V O 14.5 V
A non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos300Ot-0.5sin4000t) A is applied to the circuit shown. Find the total power? 42 iL iT 1c -J9Ω J4Ω O 55 W O 20 W 39 W O 28 W
A non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos3000t-0.5sin4000t) A is * ?applied to the circuit shown. Find the total power 4Ω www 42 iL iT -J92 J42 55 W 28 W 20 W 39 W O
A non-sinusoidal current source (iT=2+1.5sin10o0t+ 1cos3000t-0.5sin4000t) A is applied to the circuit shown. Find the total power? * İL iT ic -J9Ω J4Q O 55 W 20 W 39 W 28 W
A non-sinusoidal current source (iT=2+1.5sin100t+ 1cos3000t-0.5sin4000t) A is applied to the circuit shown. Find the total power? * 42 4Ω iL www ic iT -J92 J42 O 55 W 20 W O 39 W O 28 W 1.
A non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos30o0t- 0.5sin4000t) A is applied to the * ?circuit shown. Find the total power İL iT ic -J9N J4Q 39 W O 20 W O 55 W 28 W )!( هذا السؤال مطلوب
Q5] find the current of the resistance 1892 if the value of the source is 7.4sin(100nt-44) volt Give the right choice HH 1mF ww 0.093H R1 www 180 R4 1402 3.9mF 13.100, 78.163⁰ mA 14.100, 78.163⁰ mA O 15.100, 78.163⁰ mA ·2 V1
QUESTION 3 An inductor and a 330 ohm resistor are connected in series with a function generator. The current is 89.8mA RMS 5kHz. The reactive power is 3.04 var. Find the value of the inductance. O 12mH O 24mH O 6mH O 18mH
* For the following circuit if the secondary voltage of the transformer is 20V rms, the output voltage is ZV HE +H C₁ C3 DA vor (000000000) + Vm O 55.5 V O 123.2 V O 113.1 V O 130.1 V D₁ C₂ HE + 2 Vm D₂ D3 + Ca HH 2V
QUESTION 2 A 18µF capacitor and a 270 ohm resistor are connected in series with a function generator. The supply voltage is 45V RMS 90HZ. Find the reactive power for this circuit. O 2.41 var O 7.05 var O 1.22 var O 4.55 var
Find the real and reactive power absorbed by each element in the following circuit. -j5 n HE + VE Vsi + 202 www j3 n V₂ +125/0° V rms A I +95/-10° V rms Vsz