G(s)s(s + 2)* Root-ground curve of a negative unit feedback system given as the forward-route transfer function at the bottom?KWhich of the following is true about theThe range I - real axis (-2,0) is a segment of the root-place curve.25 -II- The range on the real axis (-infinite,-2) is a segment of the root-place curve.III- A junction point on the real axis is -2.IV- adeparture point from the real axis is -0.67.А) I- П- ГVВ) 1-П-ШOC) II-IVOD) allE) II-III-IV

Given open loop transfer function is - Given that system is negative unity feedback system.

Which of the following is true about the ( + 2)* Root-ground curve of a negative unit feedback system given as the forward-route transfer function at the bottom? The range I - real axis (-2,0) is a segment of the root-place curve. II- The range on the real axis (-infinite,-2) is a segment of the root-place curve. III- A junction point on the real axis is -2. IV- a departure point from the real axis is -0.67. O A) I- II- IV OB) I-II-III OC) I-IV OD) all OE) II-III-IV

Which of the following is true about the ( + 2)* Root-ground curve of a negative unit feedback system given as the forward-route transfer function at the bottom? The range I - real axis (-2,0) is a segment of the root-place curve. II- The range on the real axis (-infinite,-2) is a segment of the root-place curve. III- A junction point on the real axis is -2. IV- a departure point from the real axis is -0.67. O A) I- II- IV OB) I-II-III OC) I-IV OD) all OE) II-III-IV

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

how to find the closed loop poles and zeros on a tf like this by hand. With unity feedback.
a) Obtain the open-loop transfer function. Go to page: 12 he closed-loop transfer function.. c) Find the value of gain and closed-loop poles at the imaginary axis crossing:... d) Write the range of k for which the closed system is stable.......….. e) Write the value of k that makes the system marginally stable:... f) What would be the period of oscillation. g) Find %OS, Tp, Ts, atk = 15. h) Find the steady-state errors when the input is r(t)= 0.62 u(t) step at k=15:.. H(s)G(s): k (s + 7)(s +1-j)(s +1+j)
2-) The AC equivalent of a feedback amplifier circuit is given in the figure on the right. (Hfe100, Va = ∞, Ic1 = 15 mA, Ic2 = 5mA and Ic3 = 5 mA) a) State the type of feedback used in the circuit, explaining the reason. b) Draw the small signal equivalent of the amplifier circuit. c) Calculate the value of β for the feedback by drawing the β circuit. d) Find the Avf = Vo / Vs closed loop gain of this circuit. e) Find the Rif and Rof values.
Ques 2: What is the Voltage series feedback? Explain the effect of feedback on gain and input, outputimpedance
Q2) Consider the following feedback system outlined in Figure Q2 Plant R(s) 10 C(s) S+1 Figure Q2 a) Derive the closed loop transfer function GRe(s). b) Calculate the value of Ky that will result in the closed loop system to have a maximum overshoot of 35% and a peak time of approximately 1 second. c) For the following systems assume zero initial conditions. Determine i) The peak overshoots. ii) Corresponding peak times iii) Decay rate characteristics. Produce a sketch of the unit step response using the above values calculated. vate ett
A feedback system root locus graph shown in figure below. For damped frequency 8.04 Hz, the gain K = 10 Imaginary Axis (seconds) ÖAN÷O-NWAGALBE -10 -20 -18 -16 Root Locus -14 -12 -10 -8 -6 -4 Real Axis (seconds) Ņ 0
a- Zero. b- Slightly different from zero. O Maximum positive or negative. d- An amplified sin wave. 9-Negative feedback reduces @ The feedback fraction. b- Distortion. c- The input offset voltage. d- The open-loop gain. 10-The input impedance of a current-voltage converter is Small. b- Large. c- Ideally zero. d- Ideally infinite. a- 11-In a linear op-amp circuit, the @ Signal are always sin wave. b- Op-amp does not go into saturation. c- Input impedance is ideally infinite. d- Gain-bandwidth product is constant.
Quiz #5: For the feedback transconductance amplifier in the Figure. The open-loop gain of opamp is A. - Find expression for A, = 1,/Vs, and ß = loNr - Find expression for A, = 1,/Vs, and B = 1/V, if A = 0 %3D I. Vs E Rz mun Ru
2-Discuss briefly the effect of both types of feedback on input and output impedance
Explain how the Nyquist stability criterion can be used to determine the stability of a closed-loop feedback system. Formulate the criterion for a system with no right-half plane open-loop poles. Q4 (a) Continued overleaf Page 4 of 10 (b) Consider the Nyquist plot of the frequency response of the system G(jw) = 500 - shown in Figure Q4 below. (jw+1)(jw+10)2 i. Explain how the gain margin can be obtained from the Nyquist plot and determine its approximate value from Figure Q4. What is the maximum value of an additional gain K for which the closed loop would still be stable? 0.5 -1 -1 -0.5 0.5 1 Real Axis Figure Q4 i. Explain how the phase margin can be obtained from the Nyquist plot and determine its approximate value from Figure Q4. Assuming that the corresponding point on the plot occurs at 4rad/s, what is the maximum delay which can be added to the system before the closed loop would become unstable? Sketch the approximate Bode diagram for the system in part (b) of the question,…
Question 5. A unity feedback system has the overall transfer function Y(s) R(s) 24 (5s + 3)(2s + 8) Determine the system type and the corresponding error constants (Kp, K, and K.) for tracking step, ramp and parabolic reference inputs in terms of ( and wn.
Consider the following feedback amplifier circuit. Assume lambda= 0, VDD RD2 R01 VinM₁ M₂ -Vout Select one: O a. none of these R₂ the open loop input resistance RinoL and the closed loop input resistances RincLare respectively: O b. RinoL = 1/gm and RincL= 1/gm(1+kA1) O C. RinoL = ∞o and Rincl= (1+ KA1) d. RinoLand RinCL = 00