The maximum load in terms of the wire’s breaking stress.

Question

Want to see the full answer?

Answer 1

Question

Chapter 12, Problem 41P

(a)

To determine

To Find:The maximum load in terms of the wire’s breaking stress.

(b)

To determine

To Find:The fractional change in length of the copper.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

A cable used to lift heavy materials like steel I-beams must be strong enough to resist breaking even under a load of 1.7 106 N. For safety, the cable must support twice that load. (a) What cross-sectional area should the cable have if it's to be made of steel? (b) By how much will a 7.0-m length of this cable stretch when subject to the 1.7 106-N load?

Assume that Young's Modulus for bone is 1.50 ✕ 1010 N/m2 and that the bone will fracture if more than 1.50 ✕ 108 N/m2 is exerted. (a) What is the maximum force that can be exerted on the femur bone in the leg if it has a minimum effective diameter of 2.30 cm in kN? (b) If a force of this magnitude is applied compressively, by how much does the 24.0 cm long bone shorten in millimeters?

The compressivestrength of our bones is important in everyday life. Young’s modulus forbone is about 1.4 * 10^10 Pa. Bone can take only about a 1.0% changein its length before fracturing. (a) What is the maximum force that canbe applied to a bone whose minimum cross-sectional area is 3.0 cm2?(This is approximately the cross-sectional area of a tibia, or shin bone,at its narrowest point.) (b) Estimate the maximum height from which a70 kg man could jump and not fracture his tibia. Take the time betweenwhen he first touches the floor and when he has stopped to be 0.030 s,and assume that the stress on his two legs is distributed equally.