Production and Operations Analysis, Seventh Edition
7th Edition
ISBN: 9781478623069
Author: Steven Nahmias, Tava Lennon Olsen
Publisher: Waveland Press, Inc.
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 13.7, Problem 32P
Summary Introduction
Interpretation:Optimal time to replace the cartridges.
Concept Introduction: The objective of optimal policy is to determine the value of ‘t’ that minimizes the total cost of maintenance and replacement over an infinite horizon. A replacement cycle is the time between successive replacements.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A producer of pocket calculators estimates that the calculators fail at a rate of one every five years. The calculators are sold for $25 each with a one-year free replacement warranty but can be purchased from an unregistered mail-order source for $18.50 without the warranty.
What length of period of the warranty equates the replacement costs of the calculator with and without the warranty?
A producer of pocket calculators estimates that the calculators fail at a rate of oneevery five years. The calculators are sold for $25 each with a one-year freereplacement warranty but can be purchased from an unregistered mail-ordersource for $18.50 without the warranty. Is it worth purchasing the calculator withthe warranty?
For Problem 37, what length of period of the warranty equates the replacementcosts of the calculator with and without the warranty?
A producer of pocket calculators estimates that the calculators fail at a rate of oneevery five years. The calculators are sold for $25 each with a one-year freereplacement warranty but can be purchased from an unregistered mail-ordersource for $18.50 without the warranty. Is it worth purchasing the calculator withthe warranty?
Chapter 13 Solutions
Production and Operations Analysis, Seventh Edition
Ch. 13.1 - Prob. 3PCh. 13.1 - Prob. 4PCh. 13.1 - Prob. 5PCh. 13.1 - Prob. 6PCh. 13.2 - Prob. 7PCh. 13.2 - Prob. 9PCh. 13.3 - Prob. 13PCh. 13.3 - Prob. 14PCh. 13.4 - Prob. 15PCh. 13.4 - Prob. 16P
Ch. 13.4 - Prob. 17PCh. 13.4 - Prob. 18PCh. 13.4 - Prob. 19PCh. 13.4 - Prob. 20PCh. 13.6 - Prob. 21PCh. 13.6 - Prob. 22PCh. 13.6 - Prob. 23PCh. 13.6 - Prob. 24PCh. 13.6 - Prob. 25PCh. 13.7 - Prob. 26PCh. 13.7 - Prob. 27PCh. 13.7 - Prob. 28PCh. 13.7 - Prob. 30PCh. 13.7 - Prob. 31PCh. 13.7 - Prob. 32PCh. 13.7 - Prob. 33PCh. 13.7 - Prob. 34PCh. 13.8 - Prob. 35PCh. 13.8 - Prob. 36PCh. 13.8 - Prob. 37PCh. 13.8 - Prob. 38PCh. 13.8 - Prob. 39PCh. 13.8 - Prob. 40PCh. 13.8 - Prob. 41PCh. 13 - Prob. 42APCh. 13 - Prob. 43APCh. 13 - Prob. 44APCh. 13 - Prob. 45APCh. 13 - Prob. 46APCh. 13 - Prob. 48APCh. 13 - Prob. 49APCh. 13 - Prob. 51APCh. 13 - Prob. 52APCh. 13 - Prob. 53AP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, operations-management and related others by exploring similar questions and additional content below.Similar questions
- A computer manufacturer discovers through experience that an average of 6 defective hard drives are found in every 100 hard drives manufactured. How many defective hard drives are expected to be found in the production of 1900 hard drives?arrow_forwardA swim club is designing a new pool to replace its old pool. The new pool would need to last for 10 years since the club is planning on relocating after 10 years. A concrete shell would cost $85,000 and last for all 10 years. Another option is to install a vinyl liner that would cost only $70,000 to install. However, the vinyl is not guaranteed to last for all 10 years, and it has a 40% chance of breaking down. Repair of the vinyl would cost $40,000 and would extend the life of the vinyl liner to the 10-year mark. If both options are acceptable to the swim club, which one minimizes cost? Support your answer with drawing a decision tree and provide your calculation.arrow_forwardMs. Suzanne Morphy is a full time architect. She is also sells vegetables on the side from a small farm she runs in her backyard. In 2018, the first year of operation, she had a loss of $42500 and deducted the maximum allowable amount. What is the amount of her farm loss carryover to future years that can be applied against future farm income? Round to the nearest dollar. Do NOT write commas, dollar signs, or decimals in your response. Your Answer: Answerarrow_forward
- Of the items produced daily by a factory, 40% come from line I and 60% from line II. Line I has a defect rate of 8%, whereas line II has a defect rate of 10%. If an item is chosen at random from the day's production, find the probability that it will not be defective.arrow_forwardA company has two products, which both sell in quantities of 20. Product A sells for $35/unit with a profit margin of 20%. Product B sells for $50/unit with a profit margin of 13%. Product A has a lost sale probability of 25% when out of stock, and Product B has a lost sale probability of 35% when out of stock. Which product is the more "expensive", in terms of lost sales, if it were to experience a stockout? O No answer text provided. O Product A O They both have the same cost of lost sales same O Product Barrow_forwardBestLine Hardware In spring of last year, BestLine Hardware undertook an ambitious program to overhaul their supply chain. In early planning, BestLine predicted that they could save over 25% of their entire supply chain costs by streamlining and optimizing their practices. One of the areas that had the most promise for savings and efficiency was that of order communication and fulfillment. In the existing system, Bestline’s inventory management department triggered a request to the ordering department. The ordering department then created an order and faxed it out to one of their suppliers. The supplier marked down on the fax what could be fulfilled against the order and would fax it back to BestLine for processing. Over time, this fax-based system proved to be inefficient and error-prone. Faxes were often lost or garbled, and hand-written comments could be very difficult to interpret accurately. As a part of their supply-chain efficiency effort, BestLine decided that they would try to…arrow_forward
- A production process contains a machine that deteriorates rapidly in both quality and output under heavy usage, so that it is inspected at the end of each day. Immediately after inspection, the condition of the machine is noted and classified into one of the four possible states: State Condition Good as new Operable-minimum deterioration Operable-major deterioration Inoperable 2 3 The process can be modeled as a Markov Chain with its (one-step) transition matrix P given by 1 7 1 - 16 8 16 3 1 1 P = 8. 4 8. 1 1 2 a. Determine the expected life of a new machine if it is replaced when it is "Inoperable". b. Determine the expected life of a new machine if it is replaced when it is either "Operable-major deterioration" or "Inoperable". c. According to the replacement rule in b., what is the percentage of machines that are replaced when they are inoperable?arrow_forwardAt an Oxford grocery store, the manager Jenny Produce buys lettuce each day to ensure really fresh produce. In her focus on quality, each morning any lettuce that is left from the previous day is sold to a dealer that resells it to farmers who use it to feed their animals. This week Jenny can buy fresh lettuce for $10.00 a box. The lettuce is sold for $22.00 a box and the dealer that sells old lettuce is willing to pay $2.00 a box. Past history says that tomorrow's demand for lettuce averages 270 boxes with a standard deviation of 44 boxes. How many boxes of lettuce should Jenny purchase tomorrow? (Use Excel's NORMSINV() function to find the Z-score. Round intermediate calculations to four decimal places. Round your answer to the nearest whole number.) I have asked this 3 times and nobody has got it right.arrow_forwardLarge-scale integrated (LSI) circuit chips are made in one department of an electronics firm. These chips are incorporated into analog devices that are then encased in epoxy. The yield is not particularly good for LSI manufacture, so the AQL specified by that department is 0.15 while the LTPD acceptable by the assembly department is 0.40. Assume the company is willing to accept a consumer's risk of 10 percent and a producer's risk of 5 percent. Find the sample size. Use Exhibit 10.16. Note: if the exact value of the computed LTPD ÷ AOQ ratio does not appear in Exhibit 10.16, use the next higher ratio. Note: Round up your answer to the next whole number. How would you tell someone to do the test?arrow_forward
- Jankord Jewelers permits the return of their diamond wedding rings, provided the return occurs within two weeks. Typically, 20 percent are returned. If nine rings are sold today, what is the probability that fewer than four will be returned? A- 0.914 B- 0.962 C- 0.923 D- 0.935arrow_forwardDeborah Holwager, a concessionaire for the Amway Center in Orlando, has developed a table of conditional values for the various alternatives (stocking decision) and states of nature (size of crowd) Alternatives States of Nature (size of crowd) Large Average Small Large Inventory Ave yge Inventory Smal Inventory $12,000 -51,000 $18,000 $15.000 $16,000 $4,000 $10,000 $5,000 Probabilities associated with the states of nature are 0.35 for a large crowd, 0.50 for an average crowd, and 0.15 for a small crowd. $6.000 a) The alternative that provides Deborah the greatest oxpected monetary value (EMV) is The EMV for this decision is s (enter your answer as a whole number).arrow_forward“As soon as the customer places an Order, it is received by the Sales department and a Sales Order is created. The Sales Order is sent to the Finance Department to check if the customer has any outstanding balance for more than 60 days. The AR Clerk at the Finance Department checks and sends the results back to the Sales Department. If there is an outstanding balance for more than 60 days, the Sales Department puts the Order on hold and notifies the customer. Otherwise, the Order Entry Clerk creates an Order Confirmation and sends it to the customer. Simultaneously a Picking List is generated and sent to the Order Fulfilment Department who picks up the next set of process steps. The Order Fulfilment Department receives the Picking List and determines which Warehouse is closest to the Customer location. The Picking List is sent to that Warehouse location. There, the items from the Picking List are picked. An Invoice is generated and printed. The items are packed along with the printed…arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Practical Management ScienceOperations ManagementISBN:9781337406659Author:WINSTON, Wayne L.Publisher:Cengage,
Practical Management Science
Operations Management
ISBN:9781337406659
Author:WINSTON, Wayne L.
Publisher:Cengage,