Answered: A 3-phase line operating at 50 Hz and…

A 3-phase line operating at 50 Hz and conduc- tors arrangement as shown in figure. Radius of each Conductor is 0.5 cm. Then the inductance is mH/km.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Related questions

Q: Let the excitation be a pulse wave with amplitude of 3V. The pulse resembles a step input when it is…

A: The circuit isWhere,

Q: Determine the voltage for t≥0 which develops across the terminals of an 8 pH inductor, if the…

A: To determine the voltage developed across the terminals of an inductor, we can use the…

Q: The small-signal resistance (i.e., dv/dl) in kn offered by the n-channel MOSFET M shown in the…

Q: The voltage across a 2F capacitor is plotted below. What is the (displacement) current through the…

Q: At the time the switch is closed in the circuit in (Figure 1), the voltage across the paralleled…

A: Given Data:An RC DC-transient circuit with,Initial Capacitor voltages,To Find:a. Percentage of…

Q: Problem#1 Determine the ohmmeter reading in the figure below. W 10 92 www 2012 www 33 02 68 1 560…

Q: 3. Refer to the Characteristic curve shown in Figure I a. Draw a load line on the characteristics…

A: “Since you have posted a question with multiple sub parts,we will provide the solution only to the…

Q: 2- a) Find V₁ ( rms) and 0 in the following circuit, if the load absorbs 2500 VA at a lagging power…

A: Step-1->

Q: The following shows the time variation of the input signals applied to the two-bit adder circuit.…

A: Given:Time variation of the inputs and carry-in of a two bit adder,To do:We have to plot the time…

Q: (b) Figure 3 shows average voltage vg, PWM generated by comparing two signals, Ver and Vref. If we…

A: The given voltage waveforms are shown below.The duty cycle is .Frequency of sawtooth waveform (same…

Q: In a multiplexer table, when the enable bit is 1, will the output for that bit be 0?

A: In this question,we have to check the statement whether it is true and false.In this question, we…

Q: the equivalent circuit model of a battery where, EMF represents the elec- tromotive force of the…

A: The given circuit is shown below.We need to determine the values of EMF and resistance by using…

Q: (Q1) For the following circuit, v₁ = 2v & v2 is a sine wave with an amplitude of 4v. V10 V20 OVO -Vs…

A: Given Data:An Op-amp with,Inverting input Non-inverting input To Find:Plots of .Plot of the output…

Q: 37. A 500 MW, 3-phase, Y-connected synchronous generator has a rated voltage of 21.5 kV at 0.85 p.f.…

A: It is given that:

Q: Given is the following resistor network: R1 22222 R2 R3 R4 Bat1 R5 Calculate the voltage across…

Q: A cos t V xΩ www O a. Zin=26,00-14,00 ohm O b. Zin=13,50-j7,00 ohm c. Zin=22,88-j12,25 ohm O d. Zin=…

Q: Consider the circuit shown in the figure. The capacitance C₂-9,3 μF. C₁ = 15 µF C₁ = 25µF 9₁ Q₂=C₂2₂…

A: The given circuit is shown below.Given values of the capacitances areF.F.F.We need to determine the…

Q: a) Consider the following circuit. Assume that the diode is modeled with an ideal diode model.…

A: Given Data:A series connection of,Three resistor of each Four diodes of each having To Find:The…

Q: Two 20 cm-long thin glass rods uniformly charged to +11nC are placed side by side, 4.0 cm apart.…

A: The length of rods, The charge, Distance between rods,

Q: So the question becomes, how much of a contribution do solar cells make to GPS?

A: Step-1->how much of a contribution do solar cells make to GPS?

Q: Can you give me matlab code this question please ?

A: The MATLAB code to sketch the polar plot and Bode diagram representation of the frequency response…

Q: 3V 100 Ω Q www t=0 s S1 1µF: 1μF • 200 Ω S2 a b t=10 ms 1μF 50 Ω www 1 mH

Q: 4. Consider the circuit shown in the following Figure. The cut-in voltage of each diode is VDO = 0.7…

A: In this questionWe need to determine the current IR1 , ID1 and ID2 and voltage Vo as shown the…

Q: What is the maximal pixel size allowable for a CCD to achieve Nyquist sampling for GFP using a 65x…

A: It is asked to determine the maximal pixel size allowable for a CCD to achieve Nyquist sampling for…

Q: Draw the Thevenin and Norton equivalents of the circuit

A: The given circuit is shown below.We need to draw the Thevenin and Norton equivalents of the circuit.

Q: Consider the circuit given below. 0.02v₁ 392 ww 592 V3 + 252 ww - V₁ + 1x 792 If Ix = 13.00 A,…

Q: 4. Refer to the Characteristic curve shown in figure 2 a. Draw a load line on the characteristics…

A: “Since you have posted question with multiple sub parts,we will provide the solution only to the…

Q: Solve for the current in the following circuit with these resistance values: R₁100 2, R₂ = 30 , R3 =…

Q: In the circuit shown in Figure, the transistor has B-40. Find the value of VB. Assume VEB=0.7 V.…

A: In the given questions we need to calculate the base voltage.

Q: For the following circuit, find ve(t) and vo(t) at: a) t=0 (ans: 100 V and 38.4 V) b) t=0 (ans: 100…

Q: The mathematical model of a system is y"(t) + ay (1) + by(t) = x (t) + cx(t) where a=4, b=1 and c=3.…

A: The question is about finding poles and zeros of the system.

Q: he mathematical model of a system is y"(t) + ay'(t) + by(t) =z" (t) + cz(t) where a=-3, b=2 and c-2.…

Q: V1 24V +1 R1 www 202 I₁ 1 R230 1₂ (3) V2 10V (+1 www 4 R5 4Ω R4 www 13 50R3 1Ω (2) 6A

Q: Q1 a. Consider you have to choose b/w the Full-Wave Bridge Rectifier (FWDR) & Center-Tapped Full…

A: Solution of question (Q1.b.):It is asked to interpret the behavior of a controlled Half-Wave…

Q: If the current flowing through a 75 mH inductor has the waveform shown in the Figure (a) sketch the…

Q: Q1 a. Consider you have to choose b/w the Full-Wave Bridge Rectifier (FWBR) & Center-Tapped Full…

A: It is an electrical device that is used to convert AC power into DC power. This DC power can be…

Q: For the BJT bias circuit shown, what is the emitter current, le, in milliamps? Use Vcc= 14V, Rb1 =…

Q: Signal and system The mathematical model of a system is y" (t) + ay'(t) + by(t) = a (t) + ca (t)…

A: For the given system the zeros and poles of the system need to be obtained and then the same should…

Q: State whether the given systems are stable, marginally stable or unstable. Also explain why. A)…

A: Since you have posted the multiple questions so we are supposed to answer 3 part only.In the given…

Q: Q1-A): Design a two pole Butterworth band pass filter with corner frequencies a 400Hz and 4000 Hz,…

A: The Butterworth filter is a type of analog electronic filter, commonly used in signal processing and…

Q: Y(s) 1 Consider system with transfer function: G(s) = U(s) s(s+1) = a) Is this system stable? b)…

A: Transfer function Y(s) /U(s) =1/[s(s+1)]As per guide lines I have answered three subparts.

Q: Electromagnetic question Consider a hollow cylindrical surface centered on the z-axis with radius r…

A: To calculate the magnetic field intensity (H) in the different regions described, we can apply…

Q: Snow that 2 [an] = Z-91 220

A: It is given that:

Q: ++. Answer: -Vo For the operational amplifier circuit shown, what is the output voltage in Volts if…

Q: (c) System A and System B are defined by a[n] = 5x[n+ 2] + x[n-2] and b[n] = 5"(x[n+2])+2,…

A: Given:System A, System B, Aim:To compare time-invariant property for both systems.

Q: With the help of a vector diagram, explain the significance of the following quantities in the open…

A: Transformer open and short circuit tests.Asked to explain significance of the following,Power…

Q: Determine the force in pounds upon each side of a coil of 40 turns carrying a current of 15 A if the…

A: Number of Turns on each side of a coil Current in the coil Axial length of the Coil Magnetic flux…

Q: 2) a) Scale the transistor sizes in the below figure to decrease the gate power by a factor of 8. b)…

A: The given circuit is shown below.We need to determine the scale the transistor sizes in the above…

Q: Employ voltage division to assist in the calculation of the voltage labeled vx in the circuit where…

A: The circuit isWhere V= 6.0 Volts.We need to determine the voltage Vx using voltage division rule.

Q: 2π Evaluate the following integral: [[t² +31-5] cos(1)8(4-1)dt

Question

A 3-phase line operating at 50 Hz and conduc-
tors arrangement as shown in figure. Radius of each
Conductor is 0.5 cm. Then the inductance is
mH/km.
2m
r = 0.5 cm
3.6
2m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data:

VIEW

Step 2: Determination of inductance per km:

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For 3-phase unsymmetrical spacing shown in figure (the diameter is 1 cm).: Find the capacitance per phase per km. 9m 12m
Find the capacitance if correct will upvote otherwise i will dislike...
Two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in parallel, and the combination is supplied from a sinusoidal voltage source. The power factor of the combination is ?
The ripple factor for pure dc is Answer:
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
What is the average power in ghe single phase ac circuit with the purely resistive load? It is sinusoidal steady state excitation.
An ac voltage represents by a sinusoidal waveform as shown in Figure 6 below. a) Define: i. The period ii. The frequency
What impedance vector - j25 represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a resistance.
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
A chopper circuit has an inductive load of 2ohm resistance and 10mH inductance. If the source voltage is 20 V and the frequency of the chopper is set to 100Hz and the on-time to 5 ms. Determine the average voltage and current, maximum and minimum load currents.
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
1.Enumerate five formulas for four series connected capacitances across Vt source and draw the circuit. 1. Enumerate five formulas for four parallel connected capacitances across Vt source and draw the circuit.