Principles of Instrumental Analysis
7th Edition
ISBN: 9781305577213
Author: Douglas A. Skoog, F. James Holler, Stanley R. Crouch
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Question
Chapter 2, Problem 2.13QAP
Interpretation Introduction
Interpretation:
Using the derived equation, the current passes through the circuit when time flows should be determined.
Concept introduction:
When a voltage source & a resistor are connected with a closed circuit a current flow starts. As the time continues the current flow reduces as the capacitor starts to store the current as electric energy. This reduction in current flow can be determined by the following equation.
Here,
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A typical exchange-current density, that for H+ discharge at platinum, is 0.79 mA cm−2 at 25 °C. Use the Butler–Volmer equation to calculate the current density at an electrode when its overpotential is (a) 10 mV, (b) 100 mV, (c) −5.0 V. Take α = 0.5.
The exchange-current density for a Pt|Fe3+,Fe2+ electrode is 2.5 mA cm−2. The standard potential of the electrode is +0.77 V. Derive an expression for the current flowing through an electrode of surface area 1.0 cm2 as a function of the potential applied to the electrode; assume standard conditions.
The resistance of a decinormal solution of a salt occupying a volume between Pt electrodes is 1.80
cm apart and 5.4 cm2 in area was found to be 32 ohms. Calculate the equivalent conductance of
the solution.
Chapter 2 Solutions
Principles of Instrumental Analysis
Knowledge Booster
Similar questions
- An air-gap parallel plate capacitor whose plates have an area of A=0,38m² are separated by a distance d=0,61m and are connected to a battery of V₁ = 1,8 V. The space between the parallel plates is partially filled (x=0,26m) with some material of dielectric constant K=4,56. Find the electric potential energy stored in the capacitor in terms of permitivity of free-space €0. Express your answer using 2 decimal places.arrow_forward4. What is the capacitance of an empty parallel-plate capacitor with metal plates that each have an area of 1.00m², separated by 1.00 mm?arrow_forwardThe classical dissociation constant of propionic acid, C2H5CO2H, is 1.34 x10-5 moldm-3 at 250C and the limiting molar conductivities at zero concentration of hydrogen and propionate ions are 349.8 and 35.8 ohm-1 cm2 mol-1 respectively. Calculation of the resistivity of 0.100 M solution of propionic acid.arrow_forward
- 9:01 A elearning.alsafwa.edu.iq الوقت المتبقي 0:43:09 1 Jlgw غير مجاب علیه بعد الدرجة من 3.00 علم هذا السؤال When a current of 0.4 A flows for 1.5 micro-seconds in a coper wire, estimate the number of electrons crossing the cross-section of the wire No. of electron= 4.8×10-19 electron No. of electron= 1.875×1012 electron No. of electron= 3x10-7 electron No. of electron= 4.8×10-26 electron الصفحة التالية الإعلاناتarrow_forwardElectrochemical detection is commonly used in combination capillary electrophoresis systems. This is a type of hydrodynamic voltammetry called flow injection, where it has been shown that ilim a U1/3, where U is the flow rate of the solution. Flow analysis of a urine sample at a thin-layer amperometric detector, with a flow-rate of 1.25mL/min, yielded a limiting current value of 1.6µA for its unknown uric acid content. A larger current of 2.4µA was observed for a sample containing 1 × 10-4 M uric acid and flowing at a rate of 0.9mL/min. Calculate the original concentration of uric acid in the samplearrow_forwardThe resistance of 0.01 M NaCl solution at 25 °C is 200 Ω. The cell constant of conductivity cell is unity. Calculate the molar conductance.arrow_forward
- The resistance of 0.01 M NaCl solution at 25° C is 200 Ω. The cell constant of the conductivity cell used is unity. Calculate the molar conductivity of the solution.arrow_forwardThe resistance of a 0.008 mol dm-³ solution of NaCl (aq) at 300 K was found to be 2.75 x 10³ . In a separate experiment, using the same conductivity cell, the resistance for a 0.1 mol dm-³ KCI aqueous solution was determined as 125.6 Q. Given that the conductivity of 0.1 mol dm-³ KCl aqueous solution at 300 K is 0.01302 S cm-1, calculate the molar conductivity of the NaCl aqueous solution.arrow_forwardSignificant evolution or deposition occurs in electrolysis only if the overpotential exceeds about 0.6 V. To illustrate this criterion calculate the effect that increasing the overpotential from 0.40 V to 0.60 V has on the current density in the electrolysis of 1.0 m NaOH(aq), which is 1.0 mA cm−2 at 0.4 V and 25 °C. Take α = 0.5. Hint: Assume that the current is entirely anodic.arrow_forward
- A current of 21.0 mA is maintained in a single circular loop of 1.40 m circumference. A magnetic field of 0.520 T is directed parallel to the plane of the loop. (a) Calculate the magnetic moment of the loop. mA. m² (b) What is the magnitude of the torque exerted by the magnetic field on the loop? Submit Answer mN m .arrow_forwardThe exchange current density at the electrode Pt| Fe3+| Fe2+ is 2.4 x 10-3 A cm-2, How many electrons are transported through the double layer per second in the cell (area of 1 cm2 each)? Estimate the number of times per second that a single atom on the surface takes part in an electron transfer event, assuming that the atom occupies 280 pm2 of the surface of the electrodearrow_forwardWhich unit is used to measure the magnitude of electricalcurrent? Which unit is used to measure the magnitude of apotential difference? Explain how electrical current and potentialdifference differ.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Principles of Instrumental AnalysisChemistryISBN:9781305577213Author:Douglas A. Skoog, F. James Holler, Stanley R. CrouchPublisher:Cengage Learning
Principles of Instrumental Analysis
Chemistry
ISBN:9781305577213
Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch
Publisher:Cengage Learning