(a)
Interpretation:
Time constant for the circuit should be calculated.
Concept introduction:
The product of RC is referred to as time constant for the circuit and is a measure of the time required for a capacitor to charge or discharge.
(b)
Interpretation:
The current, voltage drops across the capacitor and the resistor during a charging cycle at given times should be calculated.
Concept introduction:
The product of RC is referred to as time constant for the circuit and is a measure of the time required for a capacitor to charge or discharge.
Ohm’s law:
Ohm’s law describes the relationship among voltage, resistance, and current in a resistive series circuit.
V = IR
Connection between initial current and current across the capacitor (i) at given time during the charging is given by
The value of the voltage across the capacitor (Vc) at given time during the charging period can be given like this:
Vc = Voltage across the capacitor
Vs= Supply voltage
t = time
RC = time constant for RC circuit
(c)
Interpretation:
The current and voltage drops across the capacitor and the resistor during a discharging cycle at time 10 ms should be calculated.
Concept introduction:
The product of RC is referred to as time constant for the circuit and is a measure of the time required for a capacitor to charge or discharge.
Ohm’s law:
Ohm’s law describes the relationship among voltage, resistance, and current in a resistive series circuit.
V = IR
The value of the voltage across the capacitor (Vc) at given time during the charging period can be given like this:
Vc = Voltage across the capacitor
Vs= Supply voltage
t = time
RC = time constant for RC circuit
Connection between initial current and current across the capacitor (i) at given time during the discharging is given by
Want to see the full answer?
Check out a sample textbook solutionChapter 2 Solutions
Principles of Instrumental Analysis
- Resistivity measurements at 300 K show that an annealed metal single crystal has amonovacancy concentration CV = 10-9. When the same crystal is quenched from a hightemperature, the measurements indicate CV = 2x10-3. Calculate the temperature of thequench [Take Hf = 51.4 kJ/mol and R = 8.314 J/mol.K]. State any assumption involved. (5)(b) Explain why the esistivity of a metal is expected to be found more at room temperature after quenching. Hint: Use Matthiessen’s rule (find out by self-studying and cite thesource.)arrow_forwardCalculate the voltage necessary to supply a current of 6A through a 4ohms resistor.arrow_forwardWhich unit is used to measure the magnitude of electricalcurrent? Which unit is used to measure the magnitude of apotential difference? Explain how electrical current and potentialdifference differ.arrow_forward
- The electric field strength between the plates of a simple air capacitor is equal to the voltage across the plates divided by the distance between them. When a kV voltage of 64.6 V is put across the plates of such a capacitor an electric field strength of 3.4 is measured. Write an equation that will let you calculate the distance d between the plates. Your equation should contain only symbols. Be sure you define each symbol. Your equation: d = 0 Definitions of your symbols: kV 0 = 3.4 cm 0 = 64.6 V 010 X E A cm 3arrow_forward4)strip serves as the anode and is connected to the positive terminal of a power supply. The negative terminal of the power supply is connected to an insulated copper wire. An ammeter is placed in the circuit and the power supply is turned on. A current of 1.10 A flows for 6 min and 36 sec. During this time the mass loss of the metal is 0.109 g. What is the molar mass of the metal?arrow_forwardThe capacity of batteries such as the typical AA alkalinebattery is expressed in units of milliamp-hours (mAh). AnAA alkaline battery yields a nominal capacity of 2850 mAh.(a) What quantity of interest to the consumer is beingexpressed by the units of mAh? (b) The starting voltage of afresh alkaline battery is 1.55 V. The voltage decreases duringdischarge and is 0.80 V when the battery has delivered itsrated capacity. If we assume that the voltage declines linearlyas current is withdrawn, estimate the total maximumelectrical work the battery could perform during discharge.arrow_forward
- Silver is uniformly electro-deposited on a metallic vessel of surface area of 900 cm2 by passing a current of 0.5 ampere for 2 hours. Calculate the thickness of silver deposited.[Given: the density of silver is 10.5 g cm-3 and atomic mass of Ag = 108 amu.]arrow_forwardA student uses a strip of metal in an electrolysis circuit in which the metal strip serves as the anode and is connected to the positive terminal of a power supply. The negative terminal of the power supply is connected to an insulated copper wire. An ammeter is placed in the circuit and the power supply is turned on. A current of 1.13 A flows for 5 min and 50 sec. During this time the mass loss of the metal is 0.109 g. What is the molar mass of the metal?arrow_forwardA student uses a strip of metal in an electrolysis circuit in which the metal strip serves as the anode and is connected to the positive terminal of a power supply. The negative terminal of the power supply is connected to an insulated copper wire. An ammeter is placed in the circuit and the power supply is turned on. A current of 1.21 A flows for 5 min and 21 sec. During this time the mass loss of the metal is 0.118 g. What is the molar mass of the metal? Answer: 29.317 × (59) g/mol ✔arrow_forward
- Q. 5. (a) A KCI solution having N/50 normality has specific conductivity equal to 0.0102. If K* and Cl ions have ionic conductance of are 43.0 and 65.0 ohm' at the same temperature individually, determine the degree of dissociation of KCI solution. (b) A current 6.0 amperes is passed for 10 hours between copper electrodes in 800 ml of copper nitrate solution (4M). Calculate the molarity of the solution at the end of electrolysis. (c) 0.02 M CH3COOH solution has a resistance of 240 ohm with a cell constant of 0.366 cm'. Calculate the degree of dissociation and dissociation of CH3COOH at 0.02 M concentration. Given A° HCI, NaCl, CH3COONA are 435, 138 and 99 scm? mol respectively.arrow_forwardAn air-gap parallel plate capacitor whose plates have an area of A=0,38m² are separated by a distance d=0,61m and are connected to a battery of V₁ = 1,8 V. The space between the parallel plates is partially filled (x=0,26m) with some material of dielectric constant K=4,56. Find the electric potential energy stored in the capacitor in terms of permitivity of free-space €0. Express your answer using 2 decimal places.arrow_forward
- Principles of Modern ChemistryChemistryISBN:9781305079113Author:David W. Oxtoby, H. Pat Gillis, Laurie J. ButlerPublisher:Cengage LearningPrinciples of Instrumental AnalysisChemistryISBN:9781305577213Author:Douglas A. Skoog, F. James Holler, Stanley R. CrouchPublisher:Cengage LearningChemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage Learning